blob: 8a929fa91322dc3252932f874ab715541242d629 [file] [log] [blame] [edit]
if ARCH_STM32MP
config SPL
select SPL_BOARD_INIT
select SPL_CLK
select SPL_DM
select SPL_DM_SEQ_ALIAS
select SPL_DRIVERS_MISC_SUPPORT
select SPL_FRAMEWORK
select SPL_GPIO_SUPPORT
select SPL_LIBCOMMON_SUPPORT
select SPL_LIBGENERIC_SUPPORT
select SPL_OF_CONTROL
select SPL_OF_TRANSLATE
select SPL_PINCTRL
select SPL_REGMAP
select SPL_DM_RESET
select SPL_SERIAL_SUPPORT
select SPL_SYSCON
select SPL_DRIVERS_MISC_SUPPORT
imply SPL_LIBDISK_SUPPORT
config SYS_SOC
default "stm32mp"
config TARGET_STM32MP1
bool "Support stm32mp1xx"
select ARCH_SUPPORT_PSCI
select CPU_V7A
select CPU_V7_HAS_NONSEC
select CPU_V7_HAS_VIRT
select PINCTRL_STM32
select STM32_RCC
select STM32_RESET
select SYS_ARCH_TIMER
select SYSRESET_SYSCON
help
target STMicroelectronics SOC STM32MP1 family
STMicroelectronics MPU with core ARMv7
config SYS_TEXT_BASE
prompt "U-Boot base address"
default 0xC0100000
help
configure the U-Boot base address
when DDR driver is used:
DDR + 1MB (0xC0100000)
config SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION_MMC2
hex "Partition on MMC2 to use to load U-Boot from"
depends on SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION
default 1
help
Partition on the second MMC to load U-Boot from when the MMC is being
used in raw mode
source "board/st/stm32mp1/Kconfig"
# currently activated for debug / should be deactivated for real product
if DEBUG_UART
config DEBUG_UART_BOARD_INIT
default y
# debug on UART4 by default
config DEBUG_UART_BASE
default 0x40010000
# clock source is HSI on reset
config DEBUG_UART_CLOCK
default 64000000
endif
endif