| /* |
| * Copyright (C) 2013 Altera Corporation <www.altera.com> |
| * |
| * SPDX-License-Identifier: GPL-2.0+ |
| */ |
| |
| #include <common.h> |
| #include <asm/io.h> |
| #include <asm/arch/system_manager.h> |
| #include <asm/arch/fpga_manager.h> |
| |
| DECLARE_GLOBAL_DATA_PTR; |
| |
| static struct socfpga_system_manager *sysmgr_regs = |
| (struct socfpga_system_manager *)SOCFPGA_SYSMGR_ADDRESS; |
| |
| /* |
| * Populate the value for SYSMGR.FPGAINTF.MODULE based on pinmux setting. |
| * The value is not wrote to SYSMGR.FPGAINTF.MODULE but |
| * CONFIG_SYSMGR_ISWGRP_HANDOFF. |
| */ |
| static void populate_sysmgr_fpgaintf_module(void) |
| { |
| uint32_t handoff_val = 0; |
| |
| /* ISWGRP_HANDOFF_FPGAINTF */ |
| writel(0, &sysmgr_regs->iswgrp_handoff[2]); |
| |
| /* Enable the signal for those HPS peripherals that use FPGA. */ |
| if (readl(&sysmgr_regs->nandusefpga) == SYSMGR_FPGAINTF_USEFPGA) |
| handoff_val |= SYSMGR_FPGAINTF_NAND; |
| if (readl(&sysmgr_regs->rgmii1usefpga) == SYSMGR_FPGAINTF_USEFPGA) |
| handoff_val |= SYSMGR_FPGAINTF_EMAC1; |
| if (readl(&sysmgr_regs->sdmmcusefpga) == SYSMGR_FPGAINTF_USEFPGA) |
| handoff_val |= SYSMGR_FPGAINTF_SDMMC; |
| if (readl(&sysmgr_regs->rgmii0usefpga) == SYSMGR_FPGAINTF_USEFPGA) |
| handoff_val |= SYSMGR_FPGAINTF_EMAC0; |
| if (readl(&sysmgr_regs->spim0usefpga) == SYSMGR_FPGAINTF_USEFPGA) |
| handoff_val |= SYSMGR_FPGAINTF_SPIM0; |
| if (readl(&sysmgr_regs->spim1usefpga) == SYSMGR_FPGAINTF_USEFPGA) |
| handoff_val |= SYSMGR_FPGAINTF_SPIM1; |
| |
| /* populate (not writing) the value for SYSMGR.FPGAINTF.MODULE |
| based on pinmux setting */ |
| setbits_le32(&sysmgr_regs->iswgrp_handoff[2], handoff_val); |
| |
| handoff_val = readl(&sysmgr_regs->iswgrp_handoff[2]); |
| if (fpgamgr_test_fpga_ready()) { |
| /* Enable the required signals only */ |
| writel(handoff_val, &sysmgr_regs->fpgaintfgrp_module); |
| } |
| } |
| |
| /* |
| * Configure all the pin muxes |
| */ |
| void sysmgr_pinmux_init(void) |
| { |
| uint32_t regs = (uint32_t)&sysmgr_regs->emacio[0]; |
| const u8 *sys_mgr_init_table; |
| unsigned int len; |
| int i; |
| |
| sysmgr_get_pinmux_table(&sys_mgr_init_table, &len); |
| |
| for (i = 0; i < len; i++) { |
| writel(sys_mgr_init_table[i], regs); |
| regs += sizeof(regs); |
| } |
| |
| populate_sysmgr_fpgaintf_module(); |
| } |
| |
| /* |
| * This bit allows the bootrom to configure the IOs after a warm reset. |
| */ |
| void sysmgr_config_warmrstcfgio(int enable) |
| { |
| if (enable) |
| setbits_le32(&sysmgr_regs->romcodegrp_ctrl, |
| SYSMGR_ROMCODEGRP_CTRL_WARMRSTCFGIO); |
| else |
| clrbits_le32(&sysmgr_regs->romcodegrp_ctrl, |
| SYSMGR_ROMCODEGRP_CTRL_WARMRSTCFGIO); |
| } |