| // SPDX-License-Identifier: GPL-2.0 |
| /* |
| * board/renesas/alt/alt.c |
| * |
| * Copyright (C) 2014, 2015 Renesas Electronics Corporation |
| */ |
| |
| #include <common.h> |
| #include <malloc.h> |
| #include <dm.h> |
| #include <dm/platform_data/serial_sh.h> |
| #include <environment.h> |
| #include <asm/processor.h> |
| #include <asm/mach-types.h> |
| #include <asm/io.h> |
| #include <linux/errno.h> |
| #include <asm/arch/sys_proto.h> |
| #include <asm/gpio.h> |
| #include <asm/arch/rmobile.h> |
| #include <asm/arch/rcar-mstp.h> |
| #include <asm/arch/mmc.h> |
| #include <asm/arch/sh_sdhi.h> |
| #include <netdev.h> |
| #include <miiphy.h> |
| #include <i2c.h> |
| #include <div64.h> |
| #include "qos.h" |
| |
| DECLARE_GLOBAL_DATA_PTR; |
| |
| void s_init(void) |
| { |
| struct rcar_rwdt *rwdt = (struct rcar_rwdt *)RWDT_BASE; |
| struct rcar_swdt *swdt = (struct rcar_swdt *)SWDT_BASE; |
| |
| /* Watchdog init */ |
| writel(0xA5A5A500, &rwdt->rwtcsra); |
| writel(0xA5A5A500, &swdt->swtcsra); |
| |
| /* QoS */ |
| qos_init(); |
| } |
| |
| #define TMU0_MSTP125 BIT(25) |
| #define MMC0_MSTP315 BIT(15) |
| |
| #define SD1CKCR 0xE6150078 |
| #define SD_97500KHZ 0x7 |
| |
| int board_early_init_f(void) |
| { |
| /* TMU */ |
| mstp_clrbits_le32(MSTPSR1, SMSTPCR1, TMU0_MSTP125); |
| |
| /* Set SD1 to the 97.5MHz */ |
| writel(SD_97500KHZ, SD1CKCR); |
| |
| return 0; |
| } |
| |
| #define ETHERNET_PHY_RESET 56 /* GPIO 1 24 */ |
| |
| int board_init(void) |
| { |
| /* adress of boot parameters */ |
| gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100; |
| |
| /* Force ethernet PHY out of reset */ |
| gpio_request(ETHERNET_PHY_RESET, "phy_reset"); |
| gpio_direction_output(ETHERNET_PHY_RESET, 0); |
| mdelay(20); |
| gpio_direction_output(ETHERNET_PHY_RESET, 1); |
| udelay(1); |
| |
| return 0; |
| } |
| |
| int dram_init(void) |
| { |
| if (fdtdec_setup_mem_size_base() != 0) |
| return -EINVAL; |
| |
| return 0; |
| } |
| |
| int dram_init_banksize(void) |
| { |
| fdtdec_setup_memory_banksize(); |
| |
| return 0; |
| } |
| |
| /* KSZ8041RNLI */ |
| #define PHY_CONTROL1 0x1E |
| #define PHY_LED_MODE 0xC000 |
| #define PHY_LED_MODE_ACK 0x4000 |
| int board_phy_config(struct phy_device *phydev) |
| { |
| int ret = phy_read(phydev, MDIO_DEVAD_NONE, PHY_CONTROL1); |
| ret &= ~PHY_LED_MODE; |
| ret |= PHY_LED_MODE_ACK; |
| ret = phy_write(phydev, MDIO_DEVAD_NONE, PHY_CONTROL1, (u16)ret); |
| |
| return 0; |
| } |
| |
| void reset_cpu(ulong addr) |
| { |
| struct udevice *dev; |
| const u8 pmic_bus = 7; |
| const u8 pmic_addr = 0x58; |
| u8 data; |
| int ret; |
| |
| ret = i2c_get_chip_for_busnum(pmic_bus, pmic_addr, 1, &dev); |
| if (ret) |
| hang(); |
| |
| ret = dm_i2c_read(dev, 0x13, &data, 1); |
| if (ret) |
| hang(); |
| |
| data |= BIT(1); |
| |
| ret = dm_i2c_write(dev, 0x13, &data, 1); |
| if (ret) |
| hang(); |
| } |
| |
| enum env_location env_get_location(enum env_operation op, int prio) |
| { |
| const u32 load_magic = 0xb33fc0de; |
| |
| /* Block environment access if loaded using JTAG */ |
| if ((readl(CONFIG_SPL_TEXT_BASE + 0x24) == load_magic) && |
| (op != ENVOP_INIT)) |
| return ENVL_UNKNOWN; |
| |
| if (prio) |
| return ENVL_UNKNOWN; |
| |
| return ENVL_SPI_FLASH; |
| } |