| /* |
| * (C) Copyright 2000-2004 |
| * Wolfgang Denk, DENX Software Engineering, wd@denx.de. |
| * |
| * SPDX-License-Identifier: GPL-2.0+ |
| */ |
| |
| #ifndef BLK_H |
| #define BLK_H |
| |
| #ifdef CONFIG_SYS_64BIT_LBA |
| typedef uint64_t lbaint_t; |
| #define LBAFlength "ll" |
| #else |
| typedef ulong lbaint_t; |
| #define LBAFlength "l" |
| #endif |
| #define LBAF "%" LBAFlength "x" |
| #define LBAFU "%" LBAFlength "u" |
| |
| /* Interface types: */ |
| #define IF_TYPE_UNKNOWN 0 |
| #define IF_TYPE_IDE 1 |
| #define IF_TYPE_SCSI 2 |
| #define IF_TYPE_ATAPI 3 |
| #define IF_TYPE_USB 4 |
| #define IF_TYPE_DOC 5 |
| #define IF_TYPE_MMC 6 |
| #define IF_TYPE_SD 7 |
| #define IF_TYPE_SATA 8 |
| #define IF_TYPE_HOST 9 |
| #define IF_TYPE_MAX 10 /* Max number of IF_TYPE_* supported */ |
| |
| struct blk_desc { |
| int if_type; /* type of the interface */ |
| int dev; /* device number */ |
| unsigned char part_type; /* partition type */ |
| unsigned char target; /* target SCSI ID */ |
| unsigned char lun; /* target LUN */ |
| unsigned char hwpart; /* HW partition, e.g. for eMMC */ |
| unsigned char type; /* device type */ |
| unsigned char removable; /* removable device */ |
| #ifdef CONFIG_LBA48 |
| /* device can use 48bit addr (ATA/ATAPI v7) */ |
| unsigned char lba48; |
| #endif |
| lbaint_t lba; /* number of blocks */ |
| unsigned long blksz; /* block size */ |
| int log2blksz; /* for convenience: log2(blksz) */ |
| char vendor[40+1]; /* IDE model, SCSI Vendor */ |
| char product[20+1]; /* IDE Serial no, SCSI product */ |
| char revision[8+1]; /* firmware revision */ |
| unsigned long (*block_read)(struct blk_desc *block_dev, |
| lbaint_t start, |
| lbaint_t blkcnt, |
| void *buffer); |
| unsigned long (*block_write)(struct blk_desc *block_dev, |
| lbaint_t start, |
| lbaint_t blkcnt, |
| const void *buffer); |
| unsigned long (*block_erase)(struct blk_desc *block_dev, |
| lbaint_t start, |
| lbaint_t blkcnt); |
| void *priv; /* driver private struct pointer */ |
| }; |
| |
| #define BLOCK_CNT(size, blk_desc) (PAD_COUNT(size, blk_desc->blksz)) |
| #define PAD_TO_BLOCKSIZE(size, blk_desc) \ |
| (PAD_SIZE(size, blk_desc->blksz)) |
| |
| #endif |