| /* |
| * Copyright 2016 Freescale Semiconductor, Inc. |
| * Hou Zhiqiang <Zhiqiang.Hou@freescale.com> |
| * |
| * SPDX-License-Identifier: GPL-2.0+ |
| */ |
| |
| #ifndef __MC34VR500_H_ |
| #define __MC34VR500_H_ |
| |
| #include <power/pmic.h> |
| |
| #define MC34VR500_I2C_ADDR 0x08 |
| |
| /* Drivers name */ |
| #define MC34VR500_REGULATOR_DRIVER "mc34vr500_regulator" |
| |
| /* Register map */ |
| enum { |
| MC34VR500_DEVICEID = 0x00, |
| |
| MC34VR500_SILICONREVID = 0x03, |
| MC34VR500_FABID, |
| MC34VR500_INTSTAT0, |
| MC34VR500_INTMASK0, |
| MC34VR500_INTSENSE0, |
| MC34VR500_INTSTAT1, |
| MC34VR500_INTMASK1, |
| MC34VR500_INTSENSE1, |
| |
| MC34VR500_INTSTAT4 = 0x11, |
| MC34VR500_INTMASK4, |
| MC34VR500_INTSENSE4, |
| |
| MC34VR500_PWRCTL = 0x1B, |
| |
| MC34VR500_SW1VOLT = 0x2E, |
| MC34VR500_SW1STBY, |
| MC34VR500_SW1OFF, |
| MC34VR500_SW1MODE, |
| MC34VR500_SW1CONF, |
| MC34VR500_SW2VOLT, |
| MC34VR500_SW2STBY, |
| MC34VR500_SW2OFF, |
| MC34VR500_SW2MODE, |
| MC34VR500_SW2CONF, |
| |
| MC34VR500_SW3VOLT = 0x3C, |
| MC34VR500_SW3STBY, |
| MC34VR500_SW3OFF, |
| MC34VR500_SW3MODE, |
| MC34VR500_SW3CONF, |
| |
| MC34VR500_SW4VOLT = 0x4A, |
| MC34VR500_SW4STBY, |
| MC34VR500_SW4OFF, |
| MC34VR500_SW4MODE, |
| MC34VR500_SW4CONF, |
| |
| MC34VR500_REFOUTCRTRL = 0x6A, |
| |
| MC34VR500_LDO1CTL = 0x6D, |
| MC34VR500_LDO2CTL, |
| MC34VR500_LDO3CTL, |
| MC34VR500_LDO4CTL, |
| MC34VR500_LDO5CTL, |
| |
| MC34VR500_PAGE_REGISTER = 0x7F, |
| |
| /* Internal RAM */ |
| MC34VR500_SW1_VOLT = 0xA8, |
| MC34VR500_SW1_SEQ, |
| MC34VR500_SW1_CONFIG, |
| |
| MC34VR500_SW2_VOLT = 0xAC, |
| MC34VR500_SW2_SEQ, |
| MC34VR500_SW2_CONFIG, |
| |
| MC34VR500_SW3_VOLT = 0xB0, |
| MC34VR500_SW3_SEQ, |
| MC34VR500_SW3_CONFIG, |
| |
| MC34VR500_SW4_VOLT = 0xB8, |
| MC34VR500_SW4_SEQ, |
| MC34VR500_SW4_CONFIG, |
| |
| MC34VR500_REFOUT_SEQ = 0xC4, |
| |
| MC34VR500_LDO1_VOLT = 0xCC, |
| MC34VR500_LDO1_SEQ, |
| |
| MC34VR500_LDO2_VOLT = 0xD0, |
| MC34VR500_LDO2_SEQ, |
| |
| MC34VR500_LDO3_VOLT = 0xD4, |
| MC34VR500_LDO3_SEQ, |
| |
| MC34VR500_LDO4_VOLT = 0xD8, |
| MC34VR500_LDO4_SEQ, |
| |
| MC34VR500_LDO5_VOLT = 0xDC, |
| MC34VR500_LDO5_SEQ, |
| |
| MC34VR500_PU_CONFIG1 = 0xE0, |
| |
| MC34VR500_TBB_POR = 0xE4, |
| |
| MC34VR500_PWRGD_EN = 0xE8, |
| |
| MC34VR500_NUM_OF_REGS, |
| }; |
| |
| /* Registor offset based on SWxVOLT register */ |
| #define MC34VR500_VOLT_OFFSET 0 |
| #define MC34VR500_STBY_OFFSET 1 |
| #define MC34VR500_OFF_OFFSET 2 |
| #define MC34VR500_MODE_OFFSET 3 |
| #define MC34VR500_CONF_OFFSET 4 |
| |
| #define SW_MODE_MASK 0xf |
| #define SW_MODE_SHIFT 0 |
| |
| #define LDO_VOL_MASK 0xf |
| #define LDO_EN (1 << 4) |
| #define LDO_MODE_SHIFT 4 |
| #define LDO_MODE_MASK (1 << 4) |
| #define LDO_MODE_OFF 0 |
| #define LDO_MODE_ON 1 |
| |
| #define REFOUTEN (1 << 4) |
| |
| /* |
| * Regulator Mode Control |
| * |
| * OFF: The regulator is switched off and the output voltage is discharged. |
| * PFM: In this mode, the regulator is always in PFM mode, which is useful |
| * at light loads for optimized efficiency. |
| * PWM: In this mode, the regulator is always in PWM mode operation |
| * regardless of load conditions. |
| * APS: In this mode, the regulator moves automatically between pulse |
| * skipping mode and PWM mode depending on load conditions. |
| * |
| * SWxMODE[3:0] |
| * Normal Mode | Standby Mode | value |
| * OFF OFF 0x0 |
| * PWM OFF 0x1 |
| * PFM OFF 0x3 |
| * APS OFF 0x4 |
| * PWM PWM 0x5 |
| * PWM APS 0x6 |
| * APS APS 0x8 |
| * APS PFM 0xc |
| * PWM PFM 0xd |
| */ |
| #define OFF_OFF 0x0 |
| #define PWM_OFF 0x1 |
| #define PFM_OFF 0x3 |
| #define APS_OFF 0x4 |
| #define PWM_PWM 0x5 |
| #define PWM_APS 0x6 |
| #define APS_APS 0x8 |
| #define APS_PFM 0xc |
| #define PWM_PFM 0xd |
| |
| enum swx { |
| SW1 = 0, |
| SW2, |
| SW3, |
| SW4, |
| }; |
| |
| int mc34vr500_get_sw_volt(uint8_t sw); |
| int mc34vr500_set_sw_volt(uint8_t sw, int sw_volt); |
| int power_mc34vr500_init(unsigned char bus); |
| #endif /* __MC34VR500_PMIC_H_ */ |