| /* |
| * include/asm-ppc/cache.h |
| */ |
| #ifndef __ARCH_PPC_CACHE_H |
| #define __ARCH_PPC_CACHE_H |
| |
| #include <asm/processor.h> |
| |
| /* bytes per L1 cache line */ |
| #if defined(CONFIG_MPC8xx) |
| #define L1_CACHE_SHIFT 4 |
| #elif defined(CONFIG_PPC64BRIDGE) |
| #define L1_CACHE_SHIFT 7 |
| #elif defined(CONFIG_E500MC) |
| #define L1_CACHE_SHIFT 6 |
| #else |
| #define L1_CACHE_SHIFT 5 |
| #endif |
| |
| #define L1_CACHE_BYTES (1 << L1_CACHE_SHIFT) |
| |
| /* |
| * Use the L1 data cache line size value for the minimum DMA buffer alignment |
| * on PowerPC. |
| */ |
| #define ARCH_DMA_MINALIGN L1_CACHE_BYTES |
| |
| /* |
| * For compatibility reasons support the CONFIG_SYS_CACHELINE_SIZE too |
| */ |
| #ifndef CONFIG_SYS_CACHELINE_SIZE |
| #define CONFIG_SYS_CACHELINE_SIZE L1_CACHE_BYTES |
| #endif |
| |
| #define L1_CACHE_ALIGN(x) (((x)+(L1_CACHE_BYTES-1))&~(L1_CACHE_BYTES-1)) |
| #define L1_CACHE_PAGES 8 |
| |
| #define SMP_CACHE_BYTES L1_CACHE_BYTES |
| |
| #ifdef MODULE |
| #define __cacheline_aligned __attribute__((__aligned__(L1_CACHE_BYTES))) |
| #else |
| #define __cacheline_aligned \ |
| __attribute__((__aligned__(L1_CACHE_BYTES), \ |
| __section__(".data.cacheline_aligned"))) |
| #endif |
| |
| #if defined(__KERNEL__) && !defined(__ASSEMBLY__) |
| extern void flush_dcache_range(unsigned long start, unsigned long stop); |
| extern void clean_dcache_range(unsigned long start, unsigned long stop); |
| extern void invalidate_dcache_range(unsigned long start, unsigned long stop); |
| extern void flush_dcache(void); |
| extern void invalidate_dcache(void); |
| extern void invalidate_icache(void); |
| #ifdef CONFIG_SYS_INIT_RAM_LOCK |
| extern void unlock_ram_in_cache(void); |
| #endif /* CONFIG_SYS_INIT_RAM_LOCK */ |
| #endif /* __ASSEMBLY__ */ |
| |
| #if defined(__KERNEL__) && !defined(__ASSEMBLY__) |
| int l2cache_init(void); |
| void enable_cpc(void); |
| void disable_cpc_sram(void); |
| #endif |
| |
| /* prep registers for L2 */ |
| #define CACHECRBA 0x80000823 /* Cache configuration register address */ |
| #define L2CACHE_MASK 0x03 /* Mask for 2 L2 Cache bits */ |
| #define L2CACHE_512KB 0x00 /* 512KB */ |
| #define L2CACHE_256KB 0x01 /* 256KB */ |
| #define L2CACHE_1MB 0x02 /* 1MB */ |
| #define L2CACHE_NONE 0x03 /* NONE */ |
| #define L2CACHE_PARITY 0x08 /* Mask for L2 Cache Parity Protected bit */ |
| |
| #ifdef CONFIG_MPC8xx |
| /* Cache control on the MPC8xx is provided through some additional |
| * special purpose registers. |
| */ |
| #define IC_CST 560 /* Instruction cache control/status */ |
| #define IC_ADR 561 /* Address needed for some commands */ |
| #define IC_DAT 562 /* Read-only data register */ |
| #define DC_CST 568 /* Data cache control/status */ |
| #define DC_ADR 569 /* Address needed for some commands */ |
| #define DC_DAT 570 /* Read-only data register */ |
| |
| /* Commands. Only the first few are available to the instruction cache. |
| */ |
| #define IDC_ENABLE 0x02000000 /* Cache enable */ |
| #define IDC_DISABLE 0x04000000 /* Cache disable */ |
| #define IDC_LDLCK 0x06000000 /* Load and lock */ |
| #define IDC_UNLINE 0x08000000 /* Unlock line */ |
| #define IDC_UNALL 0x0a000000 /* Unlock all */ |
| #define IDC_INVALL 0x0c000000 /* Invalidate all */ |
| |
| #define DC_FLINE 0x0e000000 /* Flush data cache line */ |
| #define DC_SFWT 0x01000000 /* Set forced writethrough mode */ |
| #define DC_CFWT 0x03000000 /* Clear forced writethrough mode */ |
| #define DC_SLES 0x05000000 /* Set little endian swap mode */ |
| #define DC_CLES 0x07000000 /* Clear little endian swap mode */ |
| |
| /* Status. |
| */ |
| #define IDC_ENABLED 0x80000000 /* Cache is enabled */ |
| #define IDC_CERR1 0x00200000 /* Cache error 1 */ |
| #define IDC_CERR2 0x00100000 /* Cache error 2 */ |
| #define IDC_CERR3 0x00080000 /* Cache error 3 */ |
| |
| #define DC_DFWT 0x40000000 /* Data cache is forced write through */ |
| #define DC_LES 0x20000000 /* Caches are little endian mode */ |
| |
| #if !defined(__ASSEMBLY__) |
| static inline uint rd_ic_cst(void) |
| { |
| return mfspr(IC_CST); |
| } |
| |
| static inline void wr_ic_cst(uint val) |
| { |
| mtspr(IC_CST, val); |
| } |
| |
| static inline void wr_ic_adr(uint val) |
| { |
| mtspr(IC_ADR, val); |
| } |
| |
| static inline uint rd_dc_cst(void) |
| { |
| return mfspr(DC_CST); |
| } |
| |
| static inline void wr_dc_cst(uint val) |
| { |
| mtspr(DC_CST, val); |
| } |
| |
| static inline void wr_dc_adr(uint val) |
| { |
| mtspr(DC_ADR, val); |
| } |
| #endif |
| #endif /* CONFIG_MPC8xx */ |
| |
| #endif |