blob: b8aa104536c8478ba65163c3b6a49c5248b563c9 [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0+
/*
* Copyright 2018 NXP
*/
#include <common.h>
#include <errno.h>
#include <asm/io.h>
#include <asm/arch/ddr.h>
#include <asm/arch/clock.h>
#include <asm/arch/sys_proto.h>
void ddr4_cfg_umctl2(struct dram_cfg_param *ddrc_cfg, int num)
{
int i = 0;
for (i = 0; i < num; i++) {
reg32_write(ddrc_cfg->reg, ddrc_cfg->val);
ddrc_cfg++;
}
}
void ddr_init(struct dram_timing_info *dram_timing)
{
volatile unsigned int tmp_t;
/*
* assert [0]ddr1_preset_n, [1]ddr1_core_reset_n,
* [2]ddr1_phy_reset, [3]ddr1_phy_pwrokin_n,
* [4]src_system_rst_b!
*/
reg32_write(SRC_DDRC_RCR_ADDR, 0x8F00003F);
/* deassert [4]src_system_rst_b! */
reg32_write(SRC_DDRC_RCR_ADDR, 0x8F00000F);
/*
* change the clock source of dram_apb_clk_root
* to source 4 --800MHz/4
*/
clock_set_target_val(DRAM_APB_CLK_ROOT, CLK_ROOT_ON |
CLK_ROOT_SOURCE_SEL(4) |
CLK_ROOT_PRE_DIV(CLK_ROOT_PRE_DIV4));
dram_pll_init(MHZ(600));
reg32_write(0x303A00EC, 0x0000ffff); /* PGC_CPU_MAPPING */
reg32setbit(0x303A00F8, 5); /* PU_PGC_SW_PUP_REQ */
/* release [0]ddr1_preset_n, [3]ddr1_phy_pwrokin_n */
reg32_write(SRC_DDRC_RCR_ADDR, 0x8F000006);
reg32_write(DDRC_DBG1(0), 0x00000001);
reg32_write(DDRC_PWRCTL(0), 0x00000001);
while (0 != (0x7 & reg32_read(DDRC_STAT(0))))
;
/* config the uMCTL2's registers */
ddr4_cfg_umctl2(dram_timing->ddrc_cfg, dram_timing->ddrc_cfg_num);
reg32_write(DDRC_RFSHCTL3(0), 0x00000001);
/* RESET: <ctn> DEASSERTED */
/* RESET: <a Port 0 DEASSERTED(0) */
reg32_write(SRC_DDRC_RCR_ADDR, 0x8F000004);
reg32_write(SRC_DDRC_RCR_ADDR, 0x8F000000);
reg32_write(DDRC_DBG1(0), 0x00000000);
reg32_write(DDRC_PWRCTL(0), 0x00000aa);
reg32_write(DDRC_SWCTL(0), 0x00000000);
reg32_write(DDRC_DFIMISC(0), 0x00000000);
/* config the DDR PHY's registers */
ddr_cfg_phy(dram_timing);
do {
tmp_t = reg32_read(IP2APB_DDRPHY_IPS_BASE_ADDR(0) +
4 * 0x00020097);
} while (tmp_t != 0);
reg32_write(DDRC_DFIMISC(0), 0x00000020);
/* wait DFISTAT.dfi_init_complete to 1 */
while (0 == (0x1 & reg32_read(DDRC_DFISTAT(0))))
;
/* clear DFIMISC.dfi_init_complete_en */
reg32_write(DDRC_DFIMISC(0), 0x00000000);
/* set DFIMISC.dfi_init_complete_en again */
reg32_write(DDRC_DFIMISC(0), 0x00000001);
reg32_write(DDRC_PWRCTL(0), 0x0000088);
/*
* set SWCTL.sw_done to enable quasi-dynamic register
* programming outside reset.
*/
reg32_write(DDRC_SWCTL(0), 0x00000001);
/* wait SWSTAT.sw_done_ack to 1 */
while (0 == (0x1 & reg32_read(DDRC_SWSTAT(0))))
;
/* wait STAT to normal state */
while (0x1 != (0x7 & reg32_read(DDRC_STAT(0))))
;
reg32_write(DDRC_PWRCTL(0), 0x0000088);
reg32_write(DDRC_PCTRL_0(0), 0x00000001);
/* dis_auto-refresh is set to 0 */
reg32_write(DDRC_RFSHCTL3(0), 0x00000000);
/* save the dram timing config into memory */
dram_config_save(dram_timing, CONFIG_SAVED_DRAM_TIMING_BASE);
}