| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * (C) Copyright 2019 Rockchip Electronics Co., Ltd |
| */ |
| |
| #include <common.h> |
| #include <dm.h> |
| #include <dm/pinctrl.h> |
| #include <regmap.h> |
| |
| #include "pinctrl-rockchip.h" |
| |
| static struct rockchip_mux_route_data rk3288_mux_route_data[] = { |
| { |
| /* edphdmi_cecinoutt1 */ |
| .bank_num = 7, |
| .pin = 16, |
| .func = 2, |
| .route_offset = 0x264, |
| .route_val = BIT(16 + 12) | BIT(12), |
| }, { |
| /* edphdmi_cecinout */ |
| .bank_num = 7, |
| .pin = 23, |
| .func = 4, |
| .route_offset = 0x264, |
| .route_val = BIT(16 + 12), |
| }, |
| }; |
| |
| static int rk3288_set_mux(struct rockchip_pin_bank *bank, int pin, int mux) |
| { |
| struct rockchip_pinctrl_priv *priv = bank->priv; |
| int iomux_num = (pin / 8); |
| struct regmap *regmap; |
| int reg, ret, mask, mux_type; |
| u8 bit; |
| u32 data, route_reg, route_val; |
| |
| regmap = (bank->iomux[iomux_num].type & IOMUX_SOURCE_PMU) |
| ? priv->regmap_pmu : priv->regmap_base; |
| |
| /* get basic quadrupel of mux registers and the correct reg inside */ |
| mux_type = bank->iomux[iomux_num].type; |
| reg = bank->iomux[iomux_num].offset; |
| reg += rockchip_get_mux_data(mux_type, pin, &bit, &mask); |
| |
| if (bank->route_mask & BIT(pin)) { |
| if (rockchip_get_mux_route(bank, pin, mux, &route_reg, |
| &route_val)) { |
| ret = regmap_write(regmap, route_reg, route_val); |
| if (ret) |
| return ret; |
| } |
| } |
| |
| /* bank0 is special, there are no higher 16 bit writing bits. */ |
| if (bank->bank_num == 0) { |
| regmap_read(regmap, reg, &data); |
| data &= ~(mask << bit); |
| } else { |
| /* enable the write to the equivalent lower bits */ |
| data = (mask << (bit + 16)); |
| } |
| |
| data |= (mux & mask) << bit; |
| ret = regmap_write(regmap, reg, data); |
| |
| return ret; |
| } |
| |
| #define RK3288_PULL_OFFSET 0x140 |
| #define RK3288_PULL_PMU_OFFSET 0x64 |
| |
| static void rk3288_calc_pull_reg_and_bit(struct rockchip_pin_bank *bank, |
| int pin_num, struct regmap **regmap, |
| int *reg, u8 *bit) |
| { |
| struct rockchip_pinctrl_priv *priv = bank->priv; |
| |
| /* The first 24 pins of the first bank are located in PMU */ |
| if (bank->bank_num == 0) { |
| *regmap = priv->regmap_pmu; |
| *reg = RK3288_PULL_PMU_OFFSET; |
| } else { |
| *regmap = priv->regmap_base; |
| *reg = RK3288_PULL_OFFSET; |
| |
| /* correct the offset, as we're starting with the 2nd bank */ |
| *reg -= 0x10; |
| *reg += bank->bank_num * ROCKCHIP_PULL_BANK_STRIDE; |
| } |
| |
| *reg += ((pin_num / ROCKCHIP_PULL_PINS_PER_REG) * 4); |
| |
| *bit = (pin_num % ROCKCHIP_PULL_PINS_PER_REG); |
| *bit *= ROCKCHIP_PULL_BITS_PER_PIN; |
| } |
| |
| static int rk3288_set_pull(struct rockchip_pin_bank *bank, |
| int pin_num, int pull) |
| { |
| struct regmap *regmap; |
| int reg, ret; |
| u8 bit, type; |
| u32 data; |
| |
| if (pull == PIN_CONFIG_BIAS_PULL_PIN_DEFAULT) |
| return -ENOTSUPP; |
| |
| rk3288_calc_pull_reg_and_bit(bank, pin_num, ®map, ®, &bit); |
| type = bank->pull_type[pin_num / 8]; |
| ret = rockchip_translate_pull_value(type, pull); |
| if (ret < 0) { |
| debug("unsupported pull setting %d\n", pull); |
| return ret; |
| } |
| |
| /* bank0 is special, there are no higher 16 bit writing bits */ |
| if (bank->bank_num == 0) { |
| regmap_read(regmap, reg, &data); |
| data &= ~(((1 << ROCKCHIP_PULL_BITS_PER_PIN) - 1) << bit); |
| } else { |
| /* enable the write to the equivalent lower bits */ |
| data = ((1 << ROCKCHIP_PULL_BITS_PER_PIN) - 1) << (bit + 16); |
| } |
| |
| data |= (ret << bit); |
| ret = regmap_write(regmap, reg, data); |
| |
| return ret; |
| } |
| |
| #define RK3288_DRV_PMU_OFFSET 0x70 |
| #define RK3288_DRV_GRF_OFFSET 0x1c0 |
| |
| static void rk3288_calc_drv_reg_and_bit(struct rockchip_pin_bank *bank, |
| int pin_num, struct regmap **regmap, |
| int *reg, u8 *bit) |
| { |
| struct rockchip_pinctrl_priv *priv = bank->priv; |
| |
| /* The first 24 pins of the first bank are located in PMU */ |
| if (bank->bank_num == 0) { |
| *regmap = priv->regmap_pmu; |
| *reg = RK3288_DRV_PMU_OFFSET; |
| } else { |
| *regmap = priv->regmap_base; |
| *reg = RK3288_DRV_GRF_OFFSET; |
| |
| /* correct the offset, as we're starting with the 2nd bank */ |
| *reg -= 0x10; |
| *reg += bank->bank_num * ROCKCHIP_DRV_BANK_STRIDE; |
| } |
| |
| *reg += ((pin_num / ROCKCHIP_DRV_PINS_PER_REG) * 4); |
| *bit = (pin_num % ROCKCHIP_DRV_PINS_PER_REG); |
| *bit *= ROCKCHIP_DRV_BITS_PER_PIN; |
| } |
| |
| static int rk3288_set_drive(struct rockchip_pin_bank *bank, |
| int pin_num, int strength) |
| { |
| struct regmap *regmap; |
| int reg, ret; |
| u32 data; |
| u8 bit; |
| int type = bank->drv[pin_num / 8].drv_type; |
| |
| rk3288_calc_drv_reg_and_bit(bank, pin_num, ®map, ®, &bit); |
| ret = rockchip_translate_drive_value(type, strength); |
| if (ret < 0) { |
| debug("unsupported driver strength %d\n", strength); |
| return ret; |
| } |
| |
| /* bank0 is special, there are no higher 16 bit writing bits. */ |
| if (bank->bank_num == 0) { |
| regmap_read(regmap, reg, &data); |
| data &= ~(((1 << ROCKCHIP_DRV_BITS_PER_PIN) - 1) << bit); |
| } else { |
| /* enable the write to the equivalent lower bits */ |
| data = ((1 << ROCKCHIP_DRV_BITS_PER_PIN) - 1) << (bit + 16); |
| } |
| |
| data |= (ret << bit); |
| ret = regmap_write(regmap, reg, data); |
| return ret; |
| } |
| |
| static struct rockchip_pin_bank rk3288_pin_banks[] = { |
| PIN_BANK_IOMUX_FLAGS(0, 24, "gpio0", IOMUX_SOURCE_PMU, |
| IOMUX_SOURCE_PMU, |
| IOMUX_SOURCE_PMU, |
| IOMUX_UNROUTED |
| ), |
| PIN_BANK_IOMUX_FLAGS(1, 32, "gpio1", IOMUX_UNROUTED, |
| IOMUX_UNROUTED, |
| IOMUX_UNROUTED, |
| 0 |
| ), |
| PIN_BANK_IOMUX_FLAGS(2, 32, "gpio2", 0, 0, 0, IOMUX_UNROUTED), |
| PIN_BANK_IOMUX_FLAGS(3, 32, "gpio3", 0, 0, 0, IOMUX_WIDTH_4BIT), |
| PIN_BANK_IOMUX_FLAGS(4, 32, "gpio4", IOMUX_WIDTH_4BIT, |
| IOMUX_WIDTH_4BIT, |
| 0, |
| 0 |
| ), |
| PIN_BANK_IOMUX_FLAGS(5, 32, "gpio5", IOMUX_UNROUTED, |
| 0, |
| 0, |
| IOMUX_UNROUTED |
| ), |
| PIN_BANK_IOMUX_FLAGS(6, 32, "gpio6", 0, 0, 0, IOMUX_UNROUTED), |
| PIN_BANK_IOMUX_FLAGS(7, 32, "gpio7", 0, |
| 0, |
| IOMUX_WIDTH_4BIT, |
| IOMUX_UNROUTED |
| ), |
| PIN_BANK(8, 16, "gpio8"), |
| }; |
| |
| static struct rockchip_pin_ctrl rk3288_pin_ctrl = { |
| .pin_banks = rk3288_pin_banks, |
| .nr_banks = ARRAY_SIZE(rk3288_pin_banks), |
| .grf_mux_offset = 0x0, |
| .pmu_mux_offset = 0x84, |
| .iomux_routes = rk3288_mux_route_data, |
| .niomux_routes = ARRAY_SIZE(rk3288_mux_route_data), |
| .set_mux = rk3288_set_mux, |
| .set_pull = rk3288_set_pull, |
| .set_drive = rk3288_set_drive, |
| }; |
| |
| static const struct udevice_id rk3288_pinctrl_ids[] = { |
| { |
| .compatible = "rockchip,rk3288-pinctrl", |
| .data = (ulong)&rk3288_pin_ctrl |
| }, |
| { } |
| }; |
| |
| U_BOOT_DRIVER(pinctrl_rk3288) = { |
| .name = "rockchip_rk3288_pinctrl", |
| .id = UCLASS_PINCTRL, |
| .of_match = rk3288_pinctrl_ids, |
| .priv_auto_alloc_size = sizeof(struct rockchip_pinctrl_priv), |
| .ops = &rockchip_pinctrl_ops, |
| #if !CONFIG_IS_ENABLED(OF_PLATDATA) |
| .bind = dm_scan_fdt_dev, |
| #endif |
| .probe = rockchip_pinctrl_probe, |
| }; |