| * Texas Instruments - dp83867 Giga bit ethernet phy |
| |
| Required properties: |
| - reg - The ID number for the phy, usually a small integer |
| - ti,rx-internal-delay - RGMII Recieve Clock Delay - see dt-bindings/net/ti-dp83867.h |
| for applicable values |
| - ti,tx-internal-delay - RGMII Transmit Clock Delay - see dt-bindings/net/ti-dp83867.h |
| for applicable values |
| - ti,fifo-depth - Transmitt FIFO depth- see dt-bindings/net/ti-dp83867.h |
| for applicable values |
| - enet-phy-lane-swap - Indicates that PHY will swap the TX/RX lanes to |
| compensate for the board being designed with the lanes swapped. |
| - enet-phy-no-lane-swap - Indicates that PHY will disable swap of the |
| TX/RX lanes. |
| - ti,clk-output-sel - Clock output select - see dt-bindings/net/ti-dp83867.h |
| for applicable values |
| |
| Default child nodes are standard Ethernet PHY device |
| nodes as described in doc/devicetree/bindings/net/ethernet.txt |
| |
| Example: |
| |
| ethernet-phy@0 { |
| reg = <0>; |
| ti,rx-internal-delay = <DP83867_RGMIIDCTL_2_25_NS>; |
| ti,tx-internal-delay = <DP83867_RGMIIDCTL_2_75_NS>; |
| ti,fifo-depth = <DP83867_PHYCR_FIFO_DEPTH_4_B_NIB>; |
| enet-phy-lane-no-swap; |
| ti,clk-output-sel = <DP83867_CLK_O_SEL_CHN_A_TCLK>; |
| }; |
| |
| Datasheet can be found: |
| http://www.ti.com/product/DP83867IR/datasheet |
