blob: ab8f1a81f832d687531e4a2e3d249067b68fd823 [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0+
/*
* (C) Copyright 2016 Beniamino Galvani <b.galvani@gmail.com>
* (C) Copyright 2018 Neil Armstrong <narmstrong@baylibre.com>
*/
#include <common.h>
#include <asm/arch/boot.h>
#include <asm/arch/eth.h>
#include <asm/arch/gx.h>
#include <asm/arch/mem.h>
#include <asm/arch/meson-vpu.h>
#include <asm/io.h>
#include <asm/armv8/mmu.h>
#include <linux/sizes.h>
#include <phy.h>
DECLARE_GLOBAL_DATA_PTR;
int meson_get_boot_device(void)
{
return readl(GX_AO_SEC_GP_CFG0) & GX_AO_BOOT_DEVICE;
}
/* Configure the reserved memory zones exported by the secure registers
* into EFI and DTB reserved memory entries.
*/
void meson_init_reserved_memory(void *fdt)
{
u64 bl31_size, bl31_start;
u64 bl32_size, bl32_start;
u32 reg;
/*
* Get ARM Trusted Firmware reserved memory zones in :
* - AO_SEC_GP_CFG3: bl32 & bl31 size in KiB, can be 0
* - AO_SEC_GP_CFG5: bl31 physical start address, can be NULL
* - AO_SEC_GP_CFG4: bl32 physical start address, can be NULL
*/
reg = readl(GX_AO_SEC_GP_CFG3);
bl31_size = ((reg & GX_AO_BL31_RSVMEM_SIZE_MASK)
>> GX_AO_BL31_RSVMEM_SIZE_SHIFT) * SZ_1K;
bl32_size = (reg & GX_AO_BL32_RSVMEM_SIZE_MASK) * SZ_1K;
bl31_start = readl(GX_AO_SEC_GP_CFG5);
bl32_start = readl(GX_AO_SEC_GP_CFG4);
/*
* Early Meson GX Firmware revisions did not provide the reserved
* memory zones in the registers, keep fixed memory zone handling.
*/
if (IS_ENABLED(CONFIG_MESON_GX) &&
!reg && !bl31_start && !bl32_start) {
bl31_start = 0x10000000;
bl31_size = 0x200000;
}
/* Add first 16MiB reserved zone */
meson_board_add_reserved_memory(fdt, 0, GX_FIRMWARE_MEM_SIZE);
/* Add BL31 reserved zone */
if (bl31_start && bl31_size)
meson_board_add_reserved_memory(fdt, bl31_start, bl31_size);
/* Add BL32 reserved zone */
if (bl32_start && bl32_size)
meson_board_add_reserved_memory(fdt, bl32_start, bl32_size);
#if defined(CONFIG_VIDEO_MESON)
meson_vpu_rsv_fb(fdt);
#endif
}
phys_size_t get_effective_memsize(void)
{
/* Size is reported in MiB, convert it in bytes */
return ((readl(GX_AO_SEC_GP_CFG0) & GX_AO_MEM_SIZE_MASK)
>> GX_AO_MEM_SIZE_SHIFT) * SZ_1M;
}
static struct mm_region gx_mem_map[] = {
{
.virt = 0x0UL,
.phys = 0x0UL,
.size = 0xc0000000UL,
.attrs = PTE_BLOCK_MEMTYPE(MT_NORMAL) |
PTE_BLOCK_INNER_SHARE
}, {
.virt = 0xc0000000UL,
.phys = 0xc0000000UL,
.size = 0x30000000UL,
.attrs = PTE_BLOCK_MEMTYPE(MT_DEVICE_NGNRNE) |
PTE_BLOCK_NON_SHARE |
PTE_BLOCK_PXN | PTE_BLOCK_UXN
}, {
/* List terminator */
0,
}
};
struct mm_region *mem_map = gx_mem_map;
/* Configure the Ethernet MAC with the requested interface mode
* with some optional flags.
*/
void meson_eth_init(phy_interface_t mode, unsigned int flags)
{
switch (mode) {
case PHY_INTERFACE_MODE_RGMII:
case PHY_INTERFACE_MODE_RGMII_ID:
case PHY_INTERFACE_MODE_RGMII_RXID:
case PHY_INTERFACE_MODE_RGMII_TXID:
/* Set RGMII mode */
setbits_le32(GX_ETH_REG_0, GX_ETH_REG_0_PHY_INTF |
GX_ETH_REG_0_TX_PHASE(1) |
GX_ETH_REG_0_TX_RATIO(4) |
GX_ETH_REG_0_PHY_CLK_EN |
GX_ETH_REG_0_CLK_EN);
/* Reset to external PHY */
if(!IS_ENABLED(CONFIG_MESON_GXBB))
writel(0x2009087f, GX_ETH_REG_3);
break;
case PHY_INTERFACE_MODE_RMII:
/* Set RMII mode */
out_le32(GX_ETH_REG_0, GX_ETH_REG_0_INVERT_RMII_CLK |
GX_ETH_REG_0_CLK_EN);
/* Use GXL RMII Internal PHY (also on GXM) */
if (!IS_ENABLED(CONFIG_MESON_GXBB)) {
if ((flags & MESON_USE_INTERNAL_RMII_PHY)) {
writel(0x10110181, GX_ETH_REG_2);
writel(0xe40908ff, GX_ETH_REG_3);
} else
writel(0x2009087f, GX_ETH_REG_3);
}
break;
default:
printf("Invalid Ethernet interface mode\n");
return;
}
/* Enable power gate */
clrbits_le32(GX_MEM_PD_REG_0, GX_MEM_PD_REG_0_ETH_MASK);
}