| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Copyright (C) 2014 Gateworks Corporation |
| * Author: Tim Harvey <tharvey@gateworks.com> |
| */ |
| #include <common.h> |
| #include <nand.h> |
| #include <malloc.h> |
| #include <mxs_nand.h> |
| |
| static struct mtd_info *mtd; |
| static struct nand_chip nand_chip; |
| |
| static void mxs_nand_command(struct mtd_info *mtd, unsigned int command, |
| int column, int page_addr) |
| { |
| register struct nand_chip *chip = mtd_to_nand(mtd); |
| u32 timeo, time_start; |
| |
| /* write out the command to the device */ |
| chip->cmd_ctrl(mtd, command, NAND_CLE); |
| |
| /* Serially input address */ |
| if (column != -1) { |
| chip->cmd_ctrl(mtd, column, NAND_ALE); |
| chip->cmd_ctrl(mtd, column >> 8, NAND_ALE); |
| } |
| if (page_addr != -1) { |
| chip->cmd_ctrl(mtd, page_addr, NAND_ALE); |
| chip->cmd_ctrl(mtd, page_addr >> 8, NAND_ALE); |
| /* One more address cycle for devices > 128MiB */ |
| if (chip->chipsize > (128 << 20)) |
| chip->cmd_ctrl(mtd, page_addr >> 16, NAND_ALE); |
| } |
| chip->cmd_ctrl(mtd, NAND_CMD_NONE, 0); |
| |
| if (command == NAND_CMD_READ0) { |
| chip->cmd_ctrl(mtd, NAND_CMD_READSTART, NAND_CLE); |
| chip->cmd_ctrl(mtd, NAND_CMD_NONE, 0); |
| } |
| |
| /* wait for nand ready */ |
| ndelay(100); |
| timeo = (CONFIG_SYS_HZ * 20) / 1000; |
| time_start = get_timer(0); |
| while (get_timer(time_start) < timeo) { |
| if (chip->dev_ready(mtd)) |
| break; |
| } |
| } |
| |
| #if defined (CONFIG_SPL_NAND_IDENT) |
| |
| /* Trying to detect the NAND flash using ONFi, JEDEC, and (extended) IDs */ |
| static int mxs_flash_full_ident(struct mtd_info *mtd) |
| { |
| int nand_maf_id, nand_dev_id; |
| struct nand_chip *chip = mtd_to_nand(mtd); |
| struct nand_flash_dev *type; |
| |
| type = nand_get_flash_type(mtd, chip, &nand_maf_id, &nand_dev_id, NULL); |
| |
| if (IS_ERR(type)) { |
| chip->select_chip(mtd, -1); |
| return PTR_ERR(type); |
| } |
| |
| return 0; |
| } |
| |
| #else |
| |
| /* Trying to detect the NAND flash using ONFi only */ |
| static int mxs_flash_onfi_ident(struct mtd_info *mtd) |
| { |
| register struct nand_chip *chip = mtd_to_nand(mtd); |
| int i; |
| u8 mfg_id, dev_id; |
| u8 id_data[8]; |
| struct nand_onfi_params *p = &chip->onfi_params; |
| |
| /* Reset the chip */ |
| chip->cmdfunc(mtd, NAND_CMD_RESET, -1, -1); |
| |
| /* Send the command for reading device ID */ |
| chip->cmdfunc(mtd, NAND_CMD_READID, 0x00, -1); |
| |
| /* Read manufacturer and device IDs */ |
| mfg_id = chip->read_byte(mtd); |
| dev_id = chip->read_byte(mtd); |
| |
| /* Try again to make sure */ |
| chip->cmdfunc(mtd, NAND_CMD_READID, 0x00, -1); |
| for (i = 0; i < 8; i++) |
| id_data[i] = chip->read_byte(mtd); |
| if (id_data[0] != mfg_id || id_data[1] != dev_id) { |
| printf("second ID read did not match"); |
| return -1; |
| } |
| debug("0x%02x:0x%02x ", mfg_id, dev_id); |
| |
| /* read ONFI */ |
| chip->onfi_version = 0; |
| chip->cmdfunc(mtd, NAND_CMD_READID, 0x20, -1); |
| if (chip->read_byte(mtd) != 'O' || chip->read_byte(mtd) != 'N' || |
| chip->read_byte(mtd) != 'F' || chip->read_byte(mtd) != 'I') { |
| return -2; |
| } |
| |
| /* we have ONFI, probe it */ |
| chip->cmdfunc(mtd, NAND_CMD_PARAM, 0, -1); |
| chip->read_buf(mtd, (uint8_t *)p, sizeof(*p)); |
| mtd->name = p->model; |
| mtd->writesize = le32_to_cpu(p->byte_per_page); |
| mtd->erasesize = le32_to_cpu(p->pages_per_block) * mtd->writesize; |
| mtd->oobsize = le16_to_cpu(p->spare_bytes_per_page); |
| chip->chipsize = le32_to_cpu(p->blocks_per_lun); |
| chip->chipsize *= (uint64_t)mtd->erasesize * p->lun_count; |
| /* Calculate the address shift from the page size */ |
| chip->page_shift = ffs(mtd->writesize) - 1; |
| chip->phys_erase_shift = ffs(mtd->erasesize) - 1; |
| /* Convert chipsize to number of pages per chip -1 */ |
| chip->pagemask = (chip->chipsize >> chip->page_shift) - 1; |
| chip->badblockbits = 8; |
| |
| debug("erasesize=%d (>>%d)\n", mtd->erasesize, chip->phys_erase_shift); |
| debug("writesize=%d (>>%d)\n", mtd->writesize, chip->page_shift); |
| debug("oobsize=%d\n", mtd->oobsize); |
| debug("chipsize=%lld\n", chip->chipsize); |
| |
| return 0; |
| } |
| |
| #endif /* CONFIG_SPL_NAND_IDENT */ |
| |
| static int mxs_flash_ident(struct mtd_info *mtd) |
| { |
| int ret; |
| #if defined (CONFIG_SPL_NAND_IDENT) |
| ret = mxs_flash_full_ident(mtd); |
| #else |
| ret = mxs_flash_onfi_ident(mtd); |
| #endif |
| return ret; |
| } |
| |
| static int mxs_read_page_ecc(struct mtd_info *mtd, void *buf, unsigned int page) |
| { |
| register struct nand_chip *chip = mtd_to_nand(mtd); |
| int ret; |
| |
| chip->cmdfunc(mtd, NAND_CMD_READ0, 0x0, page); |
| ret = nand_chip.ecc.read_page(mtd, chip, buf, 1, page); |
| if (ret < 0) { |
| printf("read_page failed %d\n", ret); |
| return -1; |
| } |
| return 0; |
| } |
| |
| static int is_badblock(struct mtd_info *mtd, loff_t offs, int allowbbt) |
| { |
| register struct nand_chip *chip = mtd_to_nand(mtd); |
| unsigned int block = offs >> chip->phys_erase_shift; |
| unsigned int page = offs >> chip->page_shift; |
| |
| debug("%s offs=0x%08x block:%d page:%d\n", __func__, (int)offs, block, |
| page); |
| chip->cmdfunc(mtd, NAND_CMD_READ0, mtd->writesize, page); |
| memset(chip->oob_poi, 0, mtd->oobsize); |
| chip->read_buf(mtd, chip->oob_poi, mtd->oobsize); |
| |
| return chip->oob_poi[0] != 0xff; |
| } |
| |
| /* setup mtd and nand structs and init mxs_nand driver */ |
| void nand_init(void) |
| { |
| /* return if already initalized */ |
| if (nand_chip.numchips) |
| return; |
| |
| /* init mxs nand driver */ |
| mxs_nand_init_spl(&nand_chip); |
| mtd = nand_to_mtd(&nand_chip); |
| /* set mtd functions */ |
| nand_chip.cmdfunc = mxs_nand_command; |
| nand_chip.scan_bbt = nand_default_bbt; |
| nand_chip.numchips = 1; |
| |
| /* identify flash device */ |
| if (mxs_flash_ident(mtd)) { |
| printf("Failed to identify\n"); |
| nand_chip.numchips = 0; /* If fail, don't use nand */ |
| return; |
| } |
| |
| /* allocate and initialize buffers */ |
| nand_chip.buffers = memalign(ARCH_DMA_MINALIGN, |
| sizeof(*nand_chip.buffers)); |
| nand_chip.oob_poi = nand_chip.buffers->databuf + mtd->writesize; |
| /* setup flash layout (does not scan as we override that) */ |
| mtd->size = nand_chip.chipsize; |
| nand_chip.scan_bbt(mtd); |
| mxs_nand_setup_ecc(mtd); |
| } |
| |
| int nand_spl_load_image(uint32_t offs, unsigned int size, void *buf) |
| { |
| struct nand_chip *chip; |
| unsigned int page; |
| unsigned int nand_page_per_block; |
| unsigned int sz = 0; |
| |
| chip = mtd_to_nand(mtd); |
| if (!chip->numchips) |
| return -ENODEV; |
| page = offs >> chip->page_shift; |
| nand_page_per_block = mtd->erasesize / mtd->writesize; |
| |
| debug("%s offset:0x%08x len:%d page:%d\n", __func__, offs, size, page); |
| |
| size = roundup(size, mtd->writesize); |
| while (sz < size) { |
| if (mxs_read_page_ecc(mtd, buf, page) < 0) |
| return -1; |
| sz += mtd->writesize; |
| offs += mtd->writesize; |
| page++; |
| buf += mtd->writesize; |
| |
| /* |
| * Check if we have crossed a block boundary, and if so |
| * check for bad block. |
| */ |
| if (!(page % nand_page_per_block)) { |
| /* |
| * Yes, new block. See if this block is good. If not, |
| * loop until we find a good block. |
| */ |
| while (is_badblock(mtd, offs, 1)) { |
| page = page + nand_page_per_block; |
| /* Check i we've reached the end of flash. */ |
| if (page >= mtd->size >> chip->page_shift) |
| return -ENOMEM; |
| } |
| } |
| } |
| |
| return 0; |
| } |
| |
| int nand_default_bbt(struct mtd_info *mtd) |
| { |
| return 0; |
| } |
| |
| void nand_deselect(void) |
| { |
| } |
| |