| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Copyright (C) 2016 Stefan Roese <sr@denx.de> |
| */ |
| |
| #include <common.h> |
| #include <altera.h> |
| #include <errno.h> |
| #include <asm/gpio.h> |
| #include <asm/io.h> |
| #include <asm/arch/cpu.h> |
| #include <asm/arch/soc.h> |
| #include <asm/arch-mvebu/spi.h> |
| #include "theadorable.h" |
| |
| /* |
| * FPGA programming support |
| */ |
| static int fpga_pre_fn(int cookie) |
| { |
| int gpio_config = COOKIE2CONFIG(cookie); |
| int gpio_done = COOKIE2DONE(cookie); |
| int ret; |
| |
| debug("%s (%d): cookie=%08x gpio_config=%d gpio_done=%d\n", |
| __func__, __LINE__, cookie, gpio_config, gpio_done); |
| |
| /* Configure config pin */ |
| /* Set to output */ |
| ret = gpio_request(gpio_config, "CONFIG"); |
| if (ret < 0) |
| return ret; |
| gpio_direction_output(gpio_config, 1); |
| |
| /* Configure done pin */ |
| /* Set to input */ |
| ret = gpio_request(gpio_done, "DONE"); |
| if (ret < 0) |
| return ret; |
| |
| gpio_direction_input(gpio_done); |
| |
| return 0; |
| } |
| |
| static int fpga_config_fn(int assert, int flush, int cookie) |
| { |
| int gpio_config = COOKIE2CONFIG(cookie); |
| |
| debug("%s (%d): cookie=%08x gpio_config=%d\n", |
| __func__, __LINE__, cookie, gpio_config); |
| |
| if (assert) |
| gpio_set_value(gpio_config, 1); |
| else |
| gpio_set_value(gpio_config, 0); |
| |
| return 0; |
| } |
| |
| static int fpga_write_fn(const void *buf, size_t len, int flush, int cookie) |
| { |
| int spi_bus = COOKIE2SPI_BUS(cookie); |
| int spi_dev = COOKIE2SPI_DEV(cookie); |
| struct kwspi_registers *reg; |
| u32 control_reg; |
| u32 config_reg; |
| void *dst; |
| |
| /* |
| * Write data to FPGA attached to SPI bus via SPI direct write. |
| * This results in the fastest and easiest way to program the |
| * bitstream into the FPGA. |
| */ |
| debug("%s (%d): cookie=%08x spi_bus=%d spi_dev=%d\n", |
| __func__, __LINE__, cookie, spi_bus, spi_dev); |
| |
| if (spi_bus == 0) { |
| reg = (struct kwspi_registers *)MVEBU_REGISTER(0x10600); |
| dst = (void *)SPI_BUS0_DEV1_BASE; |
| } else { |
| reg = (struct kwspi_registers *)MVEBU_REGISTER(0x10680); |
| dst = (void *)SPI_BUS1_DEV2_BASE; |
| } |
| |
| /* Configure SPI controller for direct access mode */ |
| control_reg = readl(®->ctrl); |
| config_reg = readl(®->cfg); |
| writel(0x00000214, ®->cfg); /* 27MHz clock */ |
| writel(0x00000000, ®->dw_cfg); /* don't de-asset CS */ |
| writel(KWSPI_CSN_ACT, ®->ctrl); /* activate CS */ |
| |
| /* Copy data to the SPI direct mapped window */ |
| memcpy(dst, buf, len); |
| |
| /* Restore original register values */ |
| writel(control_reg, ®->ctrl); |
| writel(config_reg, ®->cfg); |
| |
| return 0; |
| } |
| |
| /* Returns the state of CONF_DONE Pin */ |
| static int fpga_done_fn(int cookie) |
| { |
| int gpio_done = COOKIE2DONE(cookie); |
| unsigned long ts; |
| |
| debug("%s (%d): cookie=%08x gpio_done=%d\n", |
| __func__, __LINE__, cookie, gpio_done); |
| |
| ts = get_timer(0); |
| do { |
| if (gpio_get_value(gpio_done)) |
| return 0; |
| } while (get_timer(ts) < 1000); |
| |
| /* timeout so return error */ |
| return -ENODEV; |
| } |
| |
| static altera_board_specific_func stratixv_fns = { |
| .pre = fpga_pre_fn, |
| .config = fpga_config_fn, |
| .write = fpga_write_fn, |
| .done = fpga_done_fn, |
| }; |
| |
| static Altera_desc altera_fpga[] = { |
| { |
| /* Family */ |
| Altera_StratixV, |
| /* Interface type */ |
| passive_serial, |
| /* No limitation as additional data will be ignored */ |
| -1, |
| /* Device function table */ |
| (void *)&stratixv_fns, |
| /* Base interface address specified in driver */ |
| NULL, |
| /* Cookie implementation */ |
| /* |
| * In this 32bit word the following information is coded: |
| * Bit 31 ... Bit 0 |
| * SPI-Bus | SPI-Dev | Config-Pin | Done-Pin |
| */ |
| FPGA_COOKIE(0, 1, 26, 7) |
| }, |
| { |
| /* Family */ |
| Altera_StratixV, |
| /* Interface type */ |
| passive_serial, |
| /* No limitation as additional data will be ignored */ |
| -1, |
| /* Device function table */ |
| (void *)&stratixv_fns, |
| /* Base interface address specified in driver */ |
| NULL, |
| /* Cookie implementation */ |
| /* |
| * In this 32bit word the following information is coded: |
| * Bit 31 ... Bit 0 |
| * SPI-Bus | SPI-Dev | Config-Pin | Done-Pin |
| */ |
| FPGA_COOKIE(1, 2, 29, 9) |
| }, |
| }; |
| |
| /* Add device descriptor to FPGA device table */ |
| void board_fpga_add(void) |
| { |
| int i; |
| |
| fpga_init(); |
| for (i = 0; i < ARRAY_SIZE(altera_fpga); i++) |
| fpga_add(fpga_altera, &altera_fpga[i]); |
| } |