| |
| menu "Partition Types" |
| |
| config PARTITIONS |
| bool "Enable Partition Labels (disklabels) support" |
| default y |
| help |
| Partition Labels (disklabels) Supported: |
| Zero or more of the following: |
| - CONFIG_MAC_PARTITION Apple's MacOS partition table. |
| - CONFIG_DOS_PARTITION MS Dos partition table, traditional on the |
| Intel architecture, USB sticks, etc. |
| - CONFIG_ISO_PARTITION ISO partition table, used on CDROM etc. |
| - CONFIG_EFI_PARTITION GPT partition table, common when EFI is the |
| bootloader. Note 2TB partition limit; see |
| disk/part_efi.c |
| - CONFIG_MTD_PARTITIONS Memory Technology Device partition table. |
| If IDE or SCSI support is enabled (CONFIG_CMD_IDE or CONFIG_SCSI) |
| you must configure support for at least one non-MTD partition type |
| as well. |
| |
| config MAC_PARTITION |
| bool "Enable Apple's MacOS partition table" |
| depends on PARTITIONS |
| help |
| Say Y here if you would like to use device under U-Boot which |
| were partitioned on a Macintosh. |
| |
| config SPL_MAC_PARTITION |
| bool "Enable Apple's MacOS partition table for SPL" |
| depends on SPL && PARTITIONS |
| default y if MAC_PARTITION |
| |
| config DOS_PARTITION |
| bool "Enable MS Dos partition table" |
| depends on PARTITIONS |
| default y if DISTRO_DEFAULTS |
| default y if x86 || CMD_FAT || USB_STORAGE |
| help |
| traditional on the Intel architecture, USB sticks, etc. |
| |
| config SPL_DOS_PARTITION |
| bool "Enable MS Dos partition table for SPL" |
| depends on SPL && PARTITIONS |
| default y if DOS_PARTITION |
| |
| config ISO_PARTITION |
| bool "Enable ISO partition table" |
| depends on PARTITIONS |
| default y if DISTRO_DEFAULTS |
| default y if MIPS || TEGRA |
| |
| config SPL_ISO_PARTITION |
| bool "Enable ISO partition table for SPL" |
| depends on SPL && PARTITIONS |
| default y if ISO_PARTITION |
| |
| config AMIGA_PARTITION |
| bool "Enable AMIGA partition table" |
| depends on PARTITIONS |
| help |
| Say Y here if you would like to use device under U-Boot which |
| were partitioned under AmigaOS. |
| |
| config SPL_AMIGA_PARTITION |
| bool "Enable AMIGA partition table for SPL" |
| depends on SPL && PARTITIONS |
| default y if AMIGA_PARTITION |
| |
| config EFI_PARTITION |
| bool "Enable EFI GPT partition table" |
| depends on PARTITIONS |
| default y if DISTRO_DEFAULTS |
| default y if TEGRA |
| help |
| Say Y here if you would like to use device under U-Boot which |
| were partitioned using EFI GPT. |
| common when EFI is the bootloader. Note 2TB partition limit; |
| see disk/part_efi.c |
| |
| config EFI_PARTITION_ENTRIES_OFF |
| int "Offset (in bytes) of the EFI partition entries" |
| depends on EFI_PARTITION |
| default 0 |
| help |
| Specify an earliest location (in bytes) where the partition |
| entries may be located. This is meant to allow "punching a |
| hole into a device" to create a gap for an SPL, its payload |
| and the U-Boot environment. |
| |
| If unsure, leave at 0 (which will locate the partition |
| entries at the first possible LBA following the GPT header). |
| |
| config SPL_EFI_PARTITION |
| bool "Enable EFI GPT partition table for SPL" |
| depends on SPL && PARTITIONS |
| default y if EFI_PARTITION |
| |
| config PARTITION_UUIDS |
| bool "Enable support of UUID for partition" |
| depends on PARTITIONS |
| default y if DISTRO_DEFAULTS |
| default y if EFI_PARTITION |
| help |
| Activate the configuration of UUID for partition |
| |
| config SPL_PARTITION_UUIDS |
| bool "Enable support of UUID for partition in SPL" |
| depends on SPL && PARTITIONS |
| default y if SPL_EFI_PARTITION |
| |
| config PARTITION_TYPE_GUID |
| bool "Enable support of GUID for partition type" |
| depends on PARTITIONS |
| depends on EFI_PARTITION |
| help |
| Activate the configuration of GUID type |
| for EFI partition |
| |
| endmenu |
