| CONFIG_ARM=y |
| CONFIG_ARCH_MESON=y |
| CONFIG_SYS_TEXT_BASE=0x01000000 |
| CONFIG_MESON_G12A=y |
| CONFIG_NR_DRAM_BANKS=1 |
| CONFIG_DEBUG_UART_BASE=0xff803000 |
| CONFIG_DEBUG_UART_CLOCK=24000000 |
| CONFIG_IDENT_STRING=" u200" |
| CONFIG_DEBUG_UART=y |
| CONFIG_OF_BOARD_SETUP=y |
| CONFIG_MISC_INIT_R=y |
| # CONFIG_DISPLAY_CPUINFO is not set |
| # CONFIG_CMD_BDI is not set |
| # CONFIG_CMD_IMI is not set |
| CONFIG_CMD_GPIO=y |
| # CONFIG_CMD_LOADS is not set |
| CONFIG_CMD_MMC=y |
| CONFIG_CMD_USB=y |
| CONFIG_CMD_USB_MASS_STORAGE=y |
| # CONFIG_CMD_SETEXPR is not set |
| CONFIG_CMD_REGULATOR=y |
| CONFIG_OF_CONTROL=y |
| CONFIG_DEFAULT_DEVICE_TREE="meson-g12a-u200" |
| CONFIG_NET_RANDOM_ETHADDR=y |
| CONFIG_DM_GPIO=y |
| CONFIG_DM_MMC=y |
| CONFIG_MMC_MESON_GX=y |
| CONFIG_PHY_ADDR_ENABLE=y |
| CONFIG_PHY_ADDR=8 |
| CONFIG_DM_ETH=y |
| CONFIG_ETH_DESIGNWARE=y |
| CONFIG_MESON_G12A_USB_PHY=y |
| CONFIG_PINCTRL=y |
| CONFIG_PINCTRL_MESON_G12A=y |
| CONFIG_DM_REGULATOR=y |
| CONFIG_DM_REGULATOR_FIXED=y |
| CONFIG_DM_RESET=y |
| CONFIG_DEBUG_UART_MESON=y |
| CONFIG_DEBUG_UART_ANNOUNCE=y |
| CONFIG_DEBUG_UART_SKIP_INIT=y |
| CONFIG_MESON_SERIAL=y |
| CONFIG_USB=y |
| CONFIG_DM_USB=y |
| CONFIG_USB_XHCI_HCD=y |
| CONFIG_USB_XHCI_DWC3=y |
| CONFIG_USB_DWC3=y |
| CONFIG_USB_DWC3_MESON_G12A=y |
| CONFIG_USB_GADGET=y |
| CONFIG_USB_GADGET_VENDOR_NUM=0x1b8e |
| CONFIG_USB_GADGET_PRODUCT_NUM=0xfada |
| CONFIG_USB_GADGET_DWC2_OTG=y |
| CONFIG_USB_GADGET_DWC2_OTG_PHY_BUS_WIDTH_8=y |
| CONFIG_USB_GADGET_DOWNLOAD=y |
| CONFIG_OF_LIBFDT_OVERLAY=y |
