| if ARCH_IMX8 |
| |
| config IMX8 |
| bool |
| |
| config MU_BASE_SPL |
| hex "MU base address used in SPL" |
| default 0x5d1b0000 |
| help |
| SPL runs in EL3 mode, it use MU0_A to communicate with SCU. |
| So we could not reuse the one in dts which is for normal U-Boot. |
| |
| config IMX8QM |
| select IMX8 |
| select SUPPORT_SPL |
| bool |
| |
| config IMX8QXP |
| select IMX8 |
| select SUPPORT_SPL |
| bool |
| |
| config SYS_SOC |
| default "imx8" |
| |
| choice |
| prompt "i.MX8 board select" |
| optional |
| |
| config TARGET_APALIS_IMX8 |
| bool "Support Apalis iMX8 module" |
| select BOARD_LATE_INIT |
| select IMX8QM |
| |
| config TARGET_COLIBRI_IMX8X |
| bool "Support Colibri iMX8X module" |
| select BOARD_LATE_INIT |
| select IMX8QXP |
| |
| config TARGET_IMX8QM_MEK |
| bool "Support i.MX8QM MEK board" |
| select BOARD_LATE_INIT |
| select IMX8QM |
| |
| config TARGET_IMX8QXP_MEK |
| bool "Support i.MX8QXP MEK board" |
| select BOARD_LATE_INIT |
| select IMX8QXP |
| |
| endchoice |
| |
| source "board/freescale/imx8qm_mek/Kconfig" |
| source "board/freescale/imx8qxp_mek/Kconfig" |
| source "board/toradex/apalis-imx8/Kconfig" |
| source "board/toradex/colibri-imx8x/Kconfig" |
| |
| endif |
