| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Copyright 2013 Freescale Semiconductor, Inc. |
| */ |
| |
| #include <common.h> |
| #include <i2c.h> |
| #include <asm/fsl_law.h> |
| #include <fsl_ddr_sdram.h> |
| #include <fsl_ddr_dimm_params.h> |
| |
| #include "cpld.h" |
| |
| #define C29XPCIE_HARDWARE_REVA 0x40 |
| /* |
| * Micron MT41J128M16HA-15E |
| * */ |
| dimm_params_t ddr_raw_timing = { |
| .n_ranks = 1, |
| .rank_density = 536870912u, |
| .capacity = 536870912u, |
| .primary_sdram_width = 32, |
| .ec_sdram_width = 8, |
| .registered_dimm = 0, |
| .mirrored_dimm = 0, |
| .n_row_addr = 14, |
| .n_col_addr = 10, |
| .n_banks_per_sdram_device = 8, |
| .edc_config = 2, |
| .burst_lengths_bitmask = 0x0c, |
| |
| .tckmin_x_ps = 1650, |
| .caslat_x = 0x7e << 4, /* 5,6,7,8,9,10 */ |
| .taa_ps = 14050, |
| .twr_ps = 15000, |
| .trcd_ps = 13500, |
| .trrd_ps = 75000, |
| .trp_ps = 13500, |
| .tras_ps = 40000, |
| .trc_ps = 49500, |
| .trfc_ps = 160000, |
| .twtr_ps = 75000, |
| .trtp_ps = 75000, |
| .refresh_rate_ps = 7800000, |
| .tfaw_ps = 30000, |
| }; |
| |
| int fsl_ddr_get_dimm_params(dimm_params_t *pdimm, |
| unsigned int controller_number, |
| unsigned int dimm_number) |
| { |
| const char dimm_model[] = "Fixed DDR on board"; |
| |
| if ((controller_number == 0) && (dimm_number == 0)) { |
| memcpy(pdimm, &ddr_raw_timing, sizeof(dimm_params_t)); |
| memset(pdimm->mpart, 0, sizeof(pdimm->mpart)); |
| memcpy(pdimm->mpart, dimm_model, sizeof(dimm_model) - 1); |
| } |
| |
| return 0; |
| } |
| |
| void fsl_ddr_board_options(memctl_options_t *popts, |
| dimm_params_t *pdimm, |
| unsigned int ctrl_num) |
| { |
| struct cpld_data *cpld_data = (void *)(CONFIG_SYS_CPLD_BASE); |
| int i; |
| |
| popts->clk_adjust = 4; |
| popts->cpo_override = 0x1f; |
| popts->write_data_delay = 4; |
| popts->half_strength_driver_enable = 1; |
| popts->bstopre = 0x3cf; |
| popts->quad_rank_present = 1; |
| popts->rtt_override = 1; |
| popts->rtt_override_value = 1; |
| popts->dynamic_power = 1; |
| /* Write leveling override */ |
| popts->wrlvl_en = 1; |
| popts->wrlvl_override = 1; |
| popts->wrlvl_sample = 0xf; |
| popts->wrlvl_start = 0x4; |
| popts->trwt_override = 1; |
| popts->trwt = 0; |
| |
| if (in_8(&cpld_data->hwver) == C29XPCIE_HARDWARE_REVA) |
| popts->ecc_mode = 0; |
| |
| for (i = 0; i < CONFIG_CHIP_SELECTS_PER_CTRL; i++) { |
| popts->cs_local_opts[i].odt_rd_cfg = FSL_DDR_ODT_NEVER; |
| popts->cs_local_opts[i].odt_wr_cfg = FSL_DDR_ODT_CS; |
| } |
| } |
| |
| void get_spd(generic_spd_eeprom_t *spd, u8 i2c_address) |
| { |
| int ret = i2c_read(i2c_address, 0, 2, (uint8_t *)spd, |
| sizeof(generic_spd_eeprom_t)); |
| |
| if (ret) { |
| printf("DDR: failed to read SPD from address %u\n", |
| i2c_address); |
| memset(spd, 0, sizeof(generic_spd_eeprom_t)); |
| } |
| } |