blob: 70e76be2a3f593e5ea09e190d4e7524ec03b6d8d [file] [log] [blame]
STMicroelectronics Flexible Memory Controller 2 (FMC2)
NAND Interface
Required properties:
- compatible: Should be one of:
* st,stm32mp15-fmc2
- reg: NAND flash controller memory areas.
First region contains the register location.
Regions 2 to 4 respectively contain the data, command,
and address space for CS0.
Regions 5 to 7 contain the same areas for CS1.
- interrupts: The interrupt number
- pinctrl-0: Standard Pinctrl phandle (see: pinctrl/pinctrl-bindings.txt)
- clocks: The clock needed by the NAND flash controller
Optional properties:
- resets: Reference to a reset controller asserting the FMC controller
- dmas: DMA specifiers (see: dma/stm32-mdma.txt)
- dma-names: Must be "tx", "rx" and "ecc"
Optional children nodes:
Children nodes represent the available NAND chips.
Optional properties:
- nand-on-flash-bbt: see nand.txt
- nand-ecc-strength: see nand.txt
- nand-ecc-step-size: see nand.txt
The following ECC strength and step size are currently supported:
- nand-ecc-strength = <1>, nand-ecc-step-size = <512> (Hamming)
- nand-ecc-strength = <4>, nand-ecc-step-size = <512> (BCH4)
- nand-ecc-strength = <8>, nand-ecc-step-size = <512> (BCH8) (default)
Example:
fmc: nand-controller@58002000 {
compatible = "st,stm32mp15-fmc2";
reg = <0x58002000 0x1000>,
<0x80000000 0x1000>,
<0x88010000 0x1000>,
<0x88020000 0x1000>,
<0x81000000 0x1000>,
<0x89010000 0x1000>,
<0x89020000 0x1000>;
interrupts = <GIC_SPI 48 IRQ_TYPE_LEVEL_HIGH>;
clocks = <&rcc FMC_K>;
resets = <&rcc FMC_R>;
pinctrl-names = "default";
pinctrl-0 = <&fmc_pins_a>;
#address-cells = <1>;
#size-cells = <0>;
nand@0 {
reg = <0>;
nand-on-flash-bbt;
#address-cells = <1>;
#size-cells = <1>;
};
};