| /* |
| * Copyright (c) 2014-2018, ARM Limited and Contributors. All rights reserved. |
| * |
| * SPDX-License-Identifier: BSD-3-Clause |
| */ |
| |
| #include <assert.h> |
| #include <stdint.h> |
| |
| #include <arch_helpers.h> |
| #include <common/debug.h> |
| #include <drivers/arm/css/css_mhu.h> |
| #include <drivers/arm/css/css_scp.h> |
| #include <drivers/arm/css/css_scpi.h> |
| #include <plat/common/platform.h> |
| #include <platform_def.h> |
| |
| /* ID of the MHU slot used for the BOM protocol */ |
| #define BOM_MHU_SLOT_ID 0 |
| |
| /* Boot commands sent from AP -> SCP */ |
| #define BOOT_CMD_INFO 0x00 |
| #define BOOT_CMD_DATA 0x01 |
| |
| /* BOM command header */ |
| typedef struct { |
| uint32_t id : 8; |
| uint32_t reserved : 24; |
| } bom_cmd_t; |
| |
| typedef struct { |
| uint32_t image_size; |
| uint32_t checksum; |
| } cmd_info_payload_t; |
| |
| /* |
| * Unlike the SCPI protocol, the boot protocol uses the same memory region |
| * for both AP -> SCP and SCP -> AP transfers; define the address of this... |
| */ |
| #define BOM_SHARED_MEM PLAT_CSS_SCP_COM_SHARED_MEM_BASE |
| #define BOM_CMD_HEADER ((bom_cmd_t *) BOM_SHARED_MEM) |
| #define BOM_CMD_PAYLOAD ((void *) (BOM_SHARED_MEM + sizeof(bom_cmd_t))) |
| |
| typedef struct { |
| /* Offset from the base address of the Trusted RAM */ |
| uint32_t offset; |
| uint32_t block_size; |
| } cmd_data_payload_t; |
| |
| /* |
| * All CSS platforms load SCP_BL2/SCP_BL2U just below BL2 (this is where BL31 |
| * usually resides except when ARM_BL31_IN_DRAM is |
| * set). Ensure that SCP_BL2/SCP_BL2U do not overflow into shared RAM and |
| * the tb_fw_config. |
| */ |
| CASSERT(SCP_BL2_LIMIT <= BL2_BASE, assert_scp_bl2_overwrite_bl2); |
| CASSERT(SCP_BL2U_LIMIT <= BL2_BASE, assert_scp_bl2u_overwrite_bl2); |
| |
| CASSERT(SCP_BL2_BASE >= ARM_TB_FW_CONFIG_LIMIT, assert_scp_bl2_overflow); |
| CASSERT(SCP_BL2U_BASE >= ARM_TB_FW_CONFIG_LIMIT, assert_scp_bl2u_overflow); |
| |
| static void scp_boot_message_start(void) |
| { |
| mhu_secure_message_start(BOM_MHU_SLOT_ID); |
| } |
| |
| static void scp_boot_message_send(size_t payload_size) |
| { |
| /* Ensure that any write to the BOM payload area is seen by SCP before |
| * we write to the MHU register. If these 2 writes were reordered by |
| * the CPU then SCP would read stale payload data */ |
| dmbst(); |
| |
| /* Send command to SCP */ |
| mhu_secure_message_send(BOM_MHU_SLOT_ID); |
| } |
| |
| static uint32_t scp_boot_message_wait(size_t size) |
| { |
| uint32_t mhu_status; |
| |
| mhu_status = mhu_secure_message_wait(); |
| |
| /* Expect an SCP Boot Protocol message, reject any other protocol */ |
| if (mhu_status != (1 << BOM_MHU_SLOT_ID)) { |
| ERROR("MHU: Unexpected protocol (MHU status: 0x%x)\n", |
| mhu_status); |
| panic(); |
| } |
| |
| /* Ensure that any read to the BOM payload area is done after reading |
| * the MHU register. If these 2 reads were reordered then the CPU would |
| * read invalid payload data */ |
| dmbld(); |
| |
| return *(uint32_t *) BOM_SHARED_MEM; |
| } |
| |
| static void scp_boot_message_end(void) |
| { |
| mhu_secure_message_end(BOM_MHU_SLOT_ID); |
| } |
| |
| int css_scp_boot_image_xfer(void *image, unsigned int image_size) |
| { |
| uint32_t response; |
| uint32_t checksum; |
| cmd_info_payload_t *cmd_info_payload; |
| cmd_data_payload_t *cmd_data_payload; |
| |
| assert((uintptr_t) image == SCP_BL2_BASE); |
| |
| if ((image_size == 0) || (image_size % 4 != 0)) { |
| ERROR("Invalid size for the SCP_BL2 image. Must be a multiple of " |
| "4 bytes and not zero (current size = 0x%x)\n", |
| image_size); |
| return -1; |
| } |
| |
| /* Extract the checksum from the image */ |
| checksum = *(uint32_t *) image; |
| image = (char *) image + sizeof(checksum); |
| image_size -= sizeof(checksum); |
| |
| mhu_secure_init(); |
| |
| VERBOSE("Send info about the SCP_BL2 image to be transferred to SCP\n"); |
| |
| /* |
| * Send information about the SCP firmware image about to be transferred |
| * to SCP |
| */ |
| scp_boot_message_start(); |
| |
| BOM_CMD_HEADER->id = BOOT_CMD_INFO; |
| cmd_info_payload = BOM_CMD_PAYLOAD; |
| cmd_info_payload->image_size = image_size; |
| cmd_info_payload->checksum = checksum; |
| |
| scp_boot_message_send(sizeof(*cmd_info_payload)); |
| #if CSS_DETECT_PRE_1_7_0_SCP |
| { |
| const uint32_t deprecated_scp_nack_cmd = 0x404; |
| uint32_t mhu_status; |
| |
| VERBOSE("Detecting SCP version incompatibility\n"); |
| |
| mhu_status = mhu_secure_message_wait(); |
| if (mhu_status == deprecated_scp_nack_cmd) { |
| ERROR("Detected an incompatible version of the SCP firmware.\n"); |
| ERROR("Only versions from v1.7.0 onwards are supported.\n"); |
| ERROR("Please update the SCP firmware.\n"); |
| return -1; |
| } |
| |
| VERBOSE("SCP version looks OK\n"); |
| } |
| #endif /* CSS_DETECT_PRE_1_7_0_SCP */ |
| response = scp_boot_message_wait(sizeof(response)); |
| scp_boot_message_end(); |
| |
| if (response != 0) { |
| ERROR("SCP BOOT_CMD_INFO returned error %u\n", response); |
| return -1; |
| } |
| |
| VERBOSE("Transferring SCP_BL2 image to SCP\n"); |
| |
| /* Transfer SCP_BL2 image to SCP */ |
| scp_boot_message_start(); |
| |
| BOM_CMD_HEADER->id = BOOT_CMD_DATA; |
| cmd_data_payload = BOM_CMD_PAYLOAD; |
| cmd_data_payload->offset = (uintptr_t) image - ARM_TRUSTED_SRAM_BASE; |
| cmd_data_payload->block_size = image_size; |
| |
| scp_boot_message_send(sizeof(*cmd_data_payload)); |
| response = scp_boot_message_wait(sizeof(response)); |
| scp_boot_message_end(); |
| |
| if (response != 0) { |
| ERROR("SCP BOOT_CMD_DATA returned error %u\n", response); |
| return -1; |
| } |
| |
| return 0; |
| } |
| |
| int css_scp_boot_ready(void) |
| { |
| VERBOSE("Waiting for SCP to signal it is ready to go on\n"); |
| |
| /* Wait for SCP to signal it's ready */ |
| return scpi_wait_ready(); |
| } |