| # | |
| # MediaTek ICUSB Driver | |
| # | |
| config MTK_USBFSH | |
| bool "MediaTek USB fullspeed Host driver" | |
| ---help--- | |
| This is support for Mediatek customized Host-only MUSB hardware | |
| The USBFSH driver remove USB Device functions | |
| And provide supports for second MODEM or ICUSB, etc. | |
| config MTK_ICUSB_SUPPORT | |
| bool "MediaTek ICUSB SIM card driver" | |
| depends on MTK_USBFSH | |
| ---help--- | |
| To support the ICUSB feature on USBFSH port | |
| ICUSB is a standard USB interface to connect special SIM card | |
| Beside normal SIM card feature, ICUSB provide more features | |
| Like Mass Storage, EEM, etc. | |
| This port is usually configured as USB port 1 on device. | |
| config MTK_DT_USB_SUPPORT | |
| bool "MediaTek USBFSH dual talk feature driver" | |
| depends on MTK_USBFSH | |
| ---help--- | |
| To enable the dual talk feature in phone over MTK_MUSBFSH USB port | |
| When there is second MODEM on the device and connected to main | |
| SoC via MTK_MUSBFSH USB port. MTK_DT_USB_SUPPORT is need for | |
| supporting dual talk to transfer data between 2 MODEMs | |
| This port is usually configured as USB port 1 on device. | |
| config MTK_MUSBFSH_QMU_SUPPORT | |
| bool "QMU Transfer mode of MediaTek MUSBFSH" | |
| depends on MTK_USBFSH | |
| ---help--- | |
| Say Y here if your system has a QMU capability for USB11 | |
| controller based on the MTK MUSBFSH IP. | |
| QMU is some kind of enhanced DMA mode by HW queeu rather | |
| than SW queue to reduce SW effort. | |
| config MTK_MUSBFSH_BIND_DEV_EP | |
| bool "MediaTek USBFSH bind device endpoints to MUSB endpoints" | |
| depends on MTK_USBFSH | |
| ---help--- | |
| Say Y here if want bind device endpoints to MUSB endpoints | |
| Unbind device endpoints when device disconnect | |
| config MTK_MUSBFSH_OCP_SUPPORT | |
| bool "Over-Current Support of MediaTek MUSBFSH" | |
| depends on MTK_USBFSH | |
| ---help--- | |
| Say Y here if your PORT1 supports over-current protect. | |
| It means that: | |
| If usb port1 port's current is over the specified current | |
| (eg: 500ma), OCP pin will protect, disable Power, then will | |
| resume. | |
| It depends the OCP HW and the design. | |
| config EDGETPU_PMIC_SUPPORT | |
| bool "EdgeTPU pmic support" | |
| ---help--- | |
| Say Y here if EDGTPU uses USB link but PMIC is controlled separately. |