| #ifndef __LINUX_SPI_GPIO_H | |
| #define __LINUX_SPI_GPIO_H | |
| /* | |
| * For each bitbanged SPI bus, set up a platform_device node with: | |
| * - name "spi_gpio" | |
| * - id the same as the SPI bus number it implements | |
| * - dev.platform data pointing to a struct spi_gpio_platform_data | |
| * | |
| * Or, see the driver code for information about speedups that are | |
| * possible on platforms that support inlined access for GPIOs (no | |
| * spi_gpio_platform_data is used). | |
| * | |
| * Use spi_board_info with these busses in the usual way, being sure | |
| * that the controller_data being the GPIO used for each device's | |
| * chipselect: | |
| * | |
| * static struct spi_board_info ... [] = { | |
| * ... | |
| * // this slave uses GPIO 42 for its chipselect | |
| * .controller_data = (void *) 42, | |
| * ... | |
| * // this one uses GPIO 86 for its chipselect | |
| * .controller_data = (void *) 86, | |
| * ... | |
| * }; | |
| * | |
| * If chipselect is not used (there's only one device on the bus), assign | |
| * SPI_GPIO_NO_CHIPSELECT to the controller_data: | |
| * .controller_data = (void *) SPI_GPIO_NO_CHIPSELECT; | |
| * | |
| * If the MISO or MOSI pin is not available then it should be set to | |
| * SPI_GPIO_NO_MISO or SPI_GPIO_NO_MOSI. | |
| * | |
| * If the bitbanged bus is later switched to a "native" controller, | |
| * that platform_device and controller_data should be removed. | |
| */ | |
| #define SPI_GPIO_NO_CHIPSELECT ((unsigned long)-1l) | |
| #define SPI_GPIO_NO_MISO ((unsigned long)-1l) | |
| #define SPI_GPIO_NO_MOSI ((unsigned long)-1l) | |
| /** | |
| * struct spi_gpio_platform_data - parameter for bitbanged SPI master | |
| * @sck: number of the GPIO used for clock output | |
| * @mosi: number of the GPIO used for Master Output, Slave In (MOSI) data | |
| * @miso: number of the GPIO used for Master Input, Slave Output (MISO) data | |
| * @num_chipselect: how many slaves to allow | |
| * | |
| * All GPIO signals used with the SPI bus managed through this driver | |
| * (chipselects, MOSI, MISO, SCK) must be configured as GPIOs, instead | |
| * of some alternate function. | |
| * | |
| * It can be convenient to use this driver with pins that have alternate | |
| * functions associated with a "native" SPI controller if a driver for that | |
| * controller is not available, or is missing important functionality. | |
| * | |
| * On platforms which can do so, configure MISO with a weak pullup unless | |
| * there's an external pullup on that signal. That saves power by avoiding | |
| * floating signals. (A weak pulldown would save power too, but many | |
| * drivers expect to see all-ones data as the no slave "response".) | |
| */ | |
| struct spi_gpio_platform_data { | |
| unsigned sck; | |
| unsigned mosi; | |
| unsigned miso; | |
| u16 num_chipselect; | |
| }; | |
| #endif /* __LINUX_SPI_GPIO_H */ |