| /* | |
| * incude/mtd/fsmc.h | |
| * | |
| * ST Microelectronics | |
| * Flexible Static Memory Controller (FSMC) | |
| * platform data interface and header file | |
| * | |
| * Copyright © 2010 ST Microelectronics | |
| * Vipin Kumar <vipin.kumar@st.com> | |
| * | |
| * This file is licensed under the terms of the GNU General Public | |
| * License version 2. This program is licensed "as is" without any | |
| * warranty of any kind, whether express or implied. | |
| */ | |
| #ifndef __MTD_FSMC_H | |
| #define __MTD_FSMC_H | |
| #include <linux/io.h> | |
| #include <linux/platform_device.h> | |
| #include <linux/mtd/physmap.h> | |
| #include <linux/types.h> | |
| #include <linux/mtd/partitions.h> | |
| #include <asm/param.h> | |
| #define FSMC_NAND_BW8 1 | |
| #define FSMC_NAND_BW16 2 | |
| #define FSMC_MAX_NOR_BANKS 4 | |
| #define FSMC_MAX_NAND_BANKS 4 | |
| #define FSMC_FLASH_WIDTH8 1 | |
| #define FSMC_FLASH_WIDTH16 2 | |
| /* fsmc controller registers for NOR flash */ | |
| #define CTRL 0x0 | |
| /* ctrl register definitions */ | |
| #define BANK_ENABLE (1 << 0) | |
| #define MUXED (1 << 1) | |
| #define NOR_DEV (2 << 2) | |
| #define WIDTH_8 (0 << 4) | |
| #define WIDTH_16 (1 << 4) | |
| #define RSTPWRDWN (1 << 6) | |
| #define WPROT (1 << 7) | |
| #define WRT_ENABLE (1 << 12) | |
| #define WAIT_ENB (1 << 13) | |
| #define CTRL_TIM 0x4 | |
| /* ctrl_tim register definitions */ | |
| #define FSMC_NOR_BANK_SZ 0x8 | |
| #define FSMC_NOR_REG_SIZE 0x40 | |
| #define FSMC_NOR_REG(base, bank, reg) (base + \ | |
| FSMC_NOR_BANK_SZ * (bank) + \ | |
| reg) | |
| /* fsmc controller registers for NAND flash */ | |
| #define PC 0x00 | |
| /* pc register definitions */ | |
| #define FSMC_RESET (1 << 0) | |
| #define FSMC_WAITON (1 << 1) | |
| #define FSMC_ENABLE (1 << 2) | |
| #define FSMC_DEVTYPE_NAND (1 << 3) | |
| #define FSMC_DEVWID_8 (0 << 4) | |
| #define FSMC_DEVWID_16 (1 << 4) | |
| #define FSMC_ECCEN (1 << 6) | |
| #define FSMC_ECCPLEN_512 (0 << 7) | |
| #define FSMC_ECCPLEN_256 (1 << 7) | |
| #define FSMC_TCLR_1 (1) | |
| #define FSMC_TCLR_SHIFT (9) | |
| #define FSMC_TCLR_MASK (0xF) | |
| #define FSMC_TAR_1 (1) | |
| #define FSMC_TAR_SHIFT (13) | |
| #define FSMC_TAR_MASK (0xF) | |
| #define STS 0x04 | |
| /* sts register definitions */ | |
| #define FSMC_CODE_RDY (1 << 15) | |
| #define COMM 0x08 | |
| /* comm register definitions */ | |
| #define FSMC_TSET_0 0 | |
| #define FSMC_TSET_SHIFT 0 | |
| #define FSMC_TSET_MASK 0xFF | |
| #define FSMC_TWAIT_6 6 | |
| #define FSMC_TWAIT_SHIFT 8 | |
| #define FSMC_TWAIT_MASK 0xFF | |
| #define FSMC_THOLD_4 4 | |
| #define FSMC_THOLD_SHIFT 16 | |
| #define FSMC_THOLD_MASK 0xFF | |
| #define FSMC_THIZ_1 1 | |
| #define FSMC_THIZ_SHIFT 24 | |
| #define FSMC_THIZ_MASK 0xFF | |
| #define ATTRIB 0x0C | |
| #define IOATA 0x10 | |
| #define ECC1 0x14 | |
| #define ECC2 0x18 | |
| #define ECC3 0x1C | |
| #define FSMC_NAND_BANK_SZ 0x20 | |
| #define FSMC_NAND_REG(base, bank, reg) (base + FSMC_NOR_REG_SIZE + \ | |
| (FSMC_NAND_BANK_SZ * (bank)) + \ | |
| reg) | |
| #define FSMC_BUSY_WAIT_TIMEOUT (1 * HZ) | |
| /* | |
| * There are 13 bytes of ecc for every 512 byte block in FSMC version 8 | |
| * and it has to be read consecutively and immediately after the 512 | |
| * byte data block for hardware to generate the error bit offsets | |
| * Managing the ecc bytes in the following way is easier. This way is | |
| * similar to oobfree structure maintained already in u-boot nand driver | |
| */ | |
| #define MAX_ECCPLACE_ENTRIES 32 | |
| struct fsmc_nand_eccplace { | |
| uint8_t offset; | |
| uint8_t length; | |
| }; | |
| struct fsmc_eccplace { | |
| struct fsmc_nand_eccplace eccplace[MAX_ECCPLACE_ENTRIES]; | |
| }; | |
| struct fsmc_nand_timings { | |
| uint8_t tclr; | |
| uint8_t tar; | |
| uint8_t thiz; | |
| uint8_t thold; | |
| uint8_t twait; | |
| uint8_t tset; | |
| }; | |
| enum access_mode { | |
| USE_DMA_ACCESS = 1, | |
| USE_WORD_ACCESS, | |
| }; | |
| /** | |
| * fsmc_nand_platform_data - platform specific NAND controller config | |
| * @partitions: partition table for the platform, use a default fallback | |
| * if this is NULL | |
| * @nr_partitions: the number of partitions in the previous entry | |
| * @options: different options for the driver | |
| * @width: bus width | |
| * @bank: default bank | |
| * @select_bank: callback to select a certain bank, this is | |
| * platform-specific. If the controller only supports one bank | |
| * this may be set to NULL | |
| */ | |
| struct fsmc_nand_platform_data { | |
| struct fsmc_nand_timings *nand_timings; | |
| struct mtd_partition *partitions; | |
| unsigned int nr_partitions; | |
| unsigned int options; | |
| unsigned int width; | |
| unsigned int bank; | |
| /* CLE, ALE offsets */ | |
| unsigned int cle_off; | |
| unsigned int ale_off; | |
| enum access_mode mode; | |
| void (*select_bank)(uint32_t bank, uint32_t busw); | |
| /* priv structures for dma accesses */ | |
| void *read_dma_priv; | |
| void *write_dma_priv; | |
| }; | |
| extern int __init fsmc_nor_init(struct platform_device *pdev, | |
| unsigned long base, uint32_t bank, uint32_t width); | |
| extern void __init fsmc_init_board_info(struct platform_device *pdev, | |
| struct mtd_partition *partitions, unsigned int nr_partitions, | |
| unsigned int width); | |
| #endif /* __MTD_FSMC_H */ |