| #ifndef __LINUX_SHAPER_H | |
| #define __LINUX_SHAPER_H | |
| #ifdef __KERNEL__ | |
| #define SHAPER_QLEN 10 | |
| /* | |
| * This is a bit speed dependent (read it shouldn't be a constant!) | |
| * | |
| * 5 is about right for 28.8 upwards. Below that double for every | |
| * halving of speed or so. - ie about 20 for 9600 baud. | |
| */ | |
| #define SHAPER_LATENCY (5*HZ) | |
| #define SHAPER_MAXSLIP 2 | |
| #define SHAPER_BURST (HZ/50) /* Good for >128K then */ | |
| struct shaper | |
| { | |
| struct sk_buff_head sendq; | |
| __u32 bytespertick; | |
| __u32 bitspersec; | |
| __u32 shapelatency; | |
| __u32 shapeclock; | |
| unsigned long recovery; /* Time we can next clock a packet out on | |
| an empty queue */ | |
| spinlock_t lock; | |
| struct net_device_stats stats; | |
| struct net_device *dev; | |
| int (*hard_start_xmit) (struct sk_buff *skb, | |
| struct net_device *dev); | |
| int (*hard_header) (struct sk_buff *skb, | |
| struct net_device *dev, | |
| unsigned short type, | |
| void *daddr, | |
| void *saddr, | |
| unsigned len); | |
| int (*rebuild_header)(struct sk_buff *skb); | |
| int (*hard_header_cache)(struct neighbour *neigh, struct hh_cache *hh); | |
| void (*header_cache_update)(struct hh_cache *hh, struct net_device *dev, unsigned char * haddr); | |
| struct net_device_stats* (*get_stats)(struct net_device *dev); | |
| struct timer_list timer; | |
| }; | |
| #endif | |
| #define SHAPER_SET_DEV 0x0001 | |
| #define SHAPER_SET_SPEED 0x0002 | |
| #define SHAPER_GET_DEV 0x0003 | |
| #define SHAPER_GET_SPEED 0x0004 | |
| struct shaperconf | |
| { | |
| __u16 ss_cmd; | |
| union | |
| { | |
| char ssu_name[14]; | |
| __u32 ssu_speed; | |
| } ss_u; | |
| #define ss_speed ss_u.ssu_speed | |
| #define ss_name ss_u.ssu_name | |
| }; | |
| #endif |