| External Memory Interface |
| ------------------------- |
| |
| The emifa node describes a simple external bus controller found on some C6X |
| SoCs. This interface provides external busses with a number of chip selects. |
| |
| Required properties: |
| |
| - compatible: must be "ti,c64x+emifa", "simple-bus" |
| - reg: register area base and size |
| - #address-cells: must be 2 (chip-select + offset) |
| - #size-cells: must be 1 |
| - ranges: mapping from EMIFA space to parent space |
| |
| |
| Optional properties: |
| |
| - ti,dscr-dev-enable: Device ID if EMIF is enabled/disabled from DSCR |
| |
| - ti,emifa-burst-priority: |
| Number of memory transfers after which the EMIF will elevate the priority |
| of the oldest command in the command FIFO. Setting this field to 255 |
| disables this feature, thereby allowing old commands to stay in the FIFO |
| indefinitely. |
| |
| - ti,emifa-ce-config: |
| Configuration values for each of the supported chip selects. |
| |
| Example: |
| |
| emifa@70000000 { |
| compatible = "ti,c64x+emifa", "simple-bus"; |
| #address-cells = <2>; |
| #size-cells = <1>; |
| reg = <0x70000000 0x100>; |
| ranges = <0x2 0x0 0xa0000000 0x00000008 |
| 0x3 0x0 0xb0000000 0x00400000 |
| 0x4 0x0 0xc0000000 0x10000000 |
| 0x5 0x0 0xD0000000 0x10000000>; |
| |
| ti,dscr-dev-enable = <13>; |
| ti,emifa-burst-priority = <255>; |
| ti,emifa-ce-config = <0x00240120 |
| 0x00240120 |
| 0x00240122 |
| 0x00240122>; |
| |
| flash@3,0 { |
| #address-cells = <1>; |
| #size-cells = <1>; |
| compatible = "cfi-flash"; |
| reg = <0x3 0x0 0x400000>; |
| bank-width = <1>; |
| device-width = <1>; |
| partition@0 { |
| reg = <0x0 0x400000>; |
| label = "NOR"; |
| }; |
| }; |
| }; |
| |
| This shows a flash chip attached to chip select 3. |
