| /* | |
| * This file is subject to the terms and conditions of the GNU General Public | |
| * License. See the file "COPYING" in the main directory of this archive | |
| * for more details. | |
| * | |
| * Copyright (c) 2005 Silicon Graphics, Inc. All Rights Reserved. | |
| */ | |
| #ifndef _LINUX_IOC4_H | |
| #define _LINUX_IOC4_H | |
| #include <linux/interrupt.h> | |
| /*************** | |
| * Definitions * | |
| ***************/ | |
| /* Miscellaneous values inherent to hardware */ | |
| #define IOC4_EXTINT_COUNT_DIVISOR 520 /* PCI clocks per COUNT tick */ | |
| /*********************************** | |
| * Structures needed by subdrivers * | |
| ***********************************/ | |
| /* This structure fully describes the IOC4 miscellaneous registers which | |
| * appear at bar[0]+0x00000 through bar[0]+0x0005c. The corresponding | |
| * PCI resource is managed by the main IOC4 driver because it contains | |
| * registers of interest to many different IOC4 subdrivers. | |
| */ | |
| struct ioc4_misc_regs { | |
| /* Miscellaneous IOC4 registers */ | |
| union ioc4_pci_err_addr_l { | |
| uint32_t raw; | |
| struct { | |
| uint32_t valid:1; /* Address captured */ | |
| uint32_t master_id:4; /* Unit causing error | |
| * 0/1: Serial port 0 TX/RX | |
| * 2/3: Serial port 1 TX/RX | |
| * 4/5: Serial port 2 TX/RX | |
| * 6/7: Serial port 3 TX/RX | |
| * 8: ATA/ATAPI | |
| * 9-15: Undefined | |
| */ | |
| uint32_t mul_err:1; /* Multiple errors occurred */ | |
| uint32_t addr:26; /* Bits 31-6 of error addr */ | |
| } fields; | |
| } pci_err_addr_l; | |
| uint32_t pci_err_addr_h; /* Bits 63-32 of error addr */ | |
| union ioc4_sio_int { | |
| uint32_t raw; | |
| struct { | |
| uint8_t tx_mt:1; /* TX ring buffer empty */ | |
| uint8_t rx_full:1; /* RX ring buffer full */ | |
| uint8_t rx_high:1; /* RX high-water exceeded */ | |
| uint8_t rx_timer:1; /* RX timer has triggered */ | |
| uint8_t delta_dcd:1; /* DELTA_DCD seen */ | |
| uint8_t delta_cts:1; /* DELTA_CTS seen */ | |
| uint8_t intr_pass:1; /* Interrupt pass-through */ | |
| uint8_t tx_explicit:1; /* TX, MCW, or delay complete */ | |
| } fields[4]; | |
| } sio_ir; /* Serial interrupt state */ | |
| union ioc4_other_int { | |
| uint32_t raw; | |
| struct { | |
| uint32_t ata_int:1; /* ATA port passthru */ | |
| uint32_t ata_memerr:1; /* ATA halted by mem error */ | |
| uint32_t memerr:4; /* Serial halted by mem err */ | |
| uint32_t kbd_int:1; /* kbd/mouse intr asserted */ | |
| uint32_t reserved:16; /* zero */ | |
| uint32_t rt_int:1; /* INT_OUT section latch */ | |
| uint32_t gen_int:8; /* Intr. from generic pins */ | |
| } fields; | |
| } other_ir; /* Other interrupt state */ | |
| union ioc4_sio_int sio_ies; /* Serial interrupt enable set */ | |
| union ioc4_other_int other_ies; /* Other interrupt enable set */ | |
| union ioc4_sio_int sio_iec; /* Serial interrupt enable clear */ | |
| union ioc4_other_int other_iec; /* Other interrupt enable clear */ | |
| union ioc4_sio_cr { | |
| uint32_t raw; | |
| struct { | |
| uint32_t cmd_pulse:4; /* Bytebus strobe width */ | |
| uint32_t arb_diag:3; /* PCI bus requester */ | |
| uint32_t sio_diag_idle:1; /* Active ser req? */ | |
| uint32_t ata_diag_idle:1; /* Active ATA req? */ | |
| uint32_t ata_diag_active:1; /* ATA req is winner */ | |
| uint32_t reserved:22; /* zero */ | |
| } fields; | |
| } sio_cr; | |
| uint32_t unused1; | |
| union ioc4_int_out { | |
| uint32_t raw; | |
| struct { | |
| uint32_t count:16; /* Period control */ | |
| uint32_t mode:3; /* Output signal shape */ | |
| uint32_t reserved:11; /* zero */ | |
| uint32_t diag:1; /* Timebase control */ | |
| uint32_t int_out:1; /* Current value */ | |
| } fields; | |
| } int_out; /* External interrupt output control */ | |
| uint32_t unused2; | |
| union ioc4_gpcr { | |
| uint32_t raw; | |
| struct { | |
| uint32_t dir:8; /* Pin direction */ | |
| uint32_t edge:8; /* Edge/level mode */ | |
| uint32_t reserved1:4; /* zero */ | |
| uint32_t int_out_en:1; /* INT_OUT enable */ | |
| uint32_t reserved2:11; /* zero */ | |
| } fields; | |
| } gpcr_s; /* Generic PIO control set */ | |
| union ioc4_gpcr gpcr_c; /* Generic PIO control clear */ | |
| union ioc4_gpdr { | |
| uint32_t raw; | |
| struct { | |
| uint32_t gen_pin:8; /* State of pins */ | |
| uint32_t reserved:24; | |
| } fields; | |
| } gpdr; /* Generic PIO data */ | |
| uint32_t unused3; | |
| union ioc4_gppr { | |
| uint32_t raw; | |
| struct { | |
| uint32_t gen_pin:1; /* Single pin state */ | |
| uint32_t reserved:31; | |
| } fields; | |
| } gppr[8]; /* Generic PIO pins */ | |
| }; | |
| /* Masks for GPCR DIR pins */ | |
| #define IOC4_GPCR_DIR_0 0x01 /* External interrupt output */ | |
| #define IOC4_GPCR_DIR_1 0x02 /* External interrupt input */ | |
| #define IOC4_GPCR_DIR_2 0x04 | |
| #define IOC4_GPCR_DIR_3 0x08 /* Keyboard/mouse presence */ | |
| #define IOC4_GPCR_DIR_4 0x10 /* Ser. port 0 xcvr select (0=232, 1=422) */ | |
| #define IOC4_GPCR_DIR_5 0x20 /* Ser. port 1 xcvr select (0=232, 1=422) */ | |
| #define IOC4_GPCR_DIR_6 0x40 /* Ser. port 2 xcvr select (0=232, 1=422) */ | |
| #define IOC4_GPCR_DIR_7 0x80 /* Ser. port 3 xcvr select (0=232, 1=422) */ | |
| /* Masks for GPCR EDGE pins */ | |
| #define IOC4_GPCR_EDGE_0 0x01 | |
| #define IOC4_GPCR_EDGE_1 0x02 /* External interrupt input */ | |
| #define IOC4_GPCR_EDGE_2 0x04 | |
| #define IOC4_GPCR_EDGE_3 0x08 | |
| #define IOC4_GPCR_EDGE_4 0x10 | |
| #define IOC4_GPCR_EDGE_5 0x20 | |
| #define IOC4_GPCR_EDGE_6 0x40 | |
| #define IOC4_GPCR_EDGE_7 0x80 | |
| #define IOC4_VARIANT_IO9 0x0900 | |
| #define IOC4_VARIANT_PCI_RT 0x0901 | |
| #define IOC4_VARIANT_IO10 0x1000 | |
| /* One of these per IOC4 */ | |
| struct ioc4_driver_data { | |
| struct list_head idd_list; | |
| unsigned long idd_bar0; | |
| struct pci_dev *idd_pdev; | |
| const struct pci_device_id *idd_pci_id; | |
| struct ioc4_misc_regs __iomem *idd_misc_regs; | |
| unsigned long count_period; | |
| void *idd_serial_data; | |
| unsigned int idd_variant; | |
| }; | |
| /* One per submodule */ | |
| struct ioc4_submodule { | |
| struct list_head is_list; | |
| char *is_name; | |
| struct module *is_owner; | |
| int (*is_probe) (struct ioc4_driver_data *); | |
| int (*is_remove) (struct ioc4_driver_data *); | |
| }; | |
| #define IOC4_NUM_CARDS 8 /* max cards per partition */ | |
| /********************************** | |
| * Functions needed by submodules * | |
| **********************************/ | |
| extern int ioc4_register_submodule(struct ioc4_submodule *); | |
| extern void ioc4_unregister_submodule(struct ioc4_submodule *); | |
| #endif /* _LINUX_IOC4_H */ |