| # |
| # MediaTek ICUSB Driver |
| # |
| |
| config MTK_USBFSH |
| bool "MediaTek USB fullspeed Host driver" |
| ---help--- |
| This is support for Mediatek customized Host-only MUSB hardware |
| The USBFSH driver remove USB Device functions |
| And provide supports for second MODEM or ICUSB, etc. |
| |
| config MTK_ICUSB_SUPPORT |
| bool "MediaTek ICUSB SIM card driver" |
| depends on MTK_USBFSH |
| ---help--- |
| To support the ICUSB feature on USBFSH port |
| ICUSB is a standard USB interface to connect special SIM card |
| Beside normal SIM card feature, ICUSB provide more features |
| Like Mass Storage, EEM, etc. |
| This port is usually configured as USB port 1 on device. |
| |
| config MTK_DT_USB_SUPPORT |
| bool "MediaTek USBFSH dual talk feature driver" |
| depends on MTK_USBFSH |
| ---help--- |
| To enable the dual talk feature in phone over MTK_MUSBFSH USB port |
| When there is second MODEM on the device and connected to main |
| SoC via MTK_MUSBFSH USB port. MTK_DT_USB_SUPPORT is need for |
| supporting dual talk to transfer data between 2 MODEMs |
| This port is usually configured as USB port 1 on device. |
| |
| config MTK_MUSBFSH_QMU_SUPPORT |
| bool "QMU Transfer mode of MediaTek MUSBFSH" |
| depends on MTK_USBFSH |
| ---help--- |
| Say Y here if your system has a QMU capability for USB11 |
| controller based on the MTK MUSBFSH IP. |
| QMU is some kind of enhanced DMA mode by HW queeu rather |
| than SW queue to reduce SW effort. |
| |
| config MTK_MUSBFSH_BIND_DEV_EP |
| bool "MediaTek USBFSH bind device endpoints to MUSB endpoints" |
| depends on MTK_USBFSH |
| ---help--- |
| Say Y here if want bind device endpoints to MUSB endpoints |
| Unbind device endpoints when device disconnect |
| |
| config MTK_MUSBFSH_OCP_SUPPORT |
| bool "Over-Current Support of MediaTek MUSBFSH" |
| depends on MTK_USBFSH |
| ---help--- |
| Say Y here if your PORT1 supports over-current protect. |
| It means that: |
| If usb port1 port's current is over the specified current |
| (eg: 500ma), OCP pin will protect, disable Power, then will |
| resume. |
| It depends the OCP HW and the design. |
| |
| config EDGETPU_PMIC_SUPPORT |
| bool "EdgeTPU pmic support" |
| ---help--- |
| Say Y here if EDGTPU uses USB link but PMIC is controlled separately. |
