Documentation/devicetree/bindings/gpio/wd,mbl-gpio.txt

Bindings for the Western Digital's MyBook Live memory-mapped GPIO controllers.

The Western Digital MyBook Live has two memory-mapped GPIO controllers.
Both GPIO controller only have a single 8-bit data register, where GPIO
state can be read and/or written.

Required properties:
	- compatible: should be "wd,mbl-gpio"
	- reg-names: must contain
		"dat" - data register
	- reg: address + size pairs describing the GPIO register sets;
		order must correspond with the order of entries in reg-names
	- #gpio-cells: must be set to 2. The first cell is the pin number and
			the second cell is used to specify the gpio polarity:
			0 = active high
			1 = active low
	- gpio-controller: Marks the device node as a gpio controller.

Optional properties:
	- no-output: GPIOs are read-only.

Examples:
	gpio0: gpio0@e0000000 {
		compatible = "wd,mbl-gpio";
		reg-names = "dat";
		reg = <0xe0000000 0x1>;
		#gpio-cells = <2>;
		gpio-controller;
	};

	gpio1: gpio1@e0100000 {
		compatible = "wd,mbl-gpio";
		reg-names = "dat";
		reg = <0xe0100000 0x1>;
		#gpio-cells = <2>;
		gpio-controller;
		no-output;
	};