| #ifndef _I386_PGTABLE_3LEVEL_H | |
| #define _I386_PGTABLE_3LEVEL_H | |
| /* | |
| * Intel Physical Address Extension (PAE) Mode - three-level page | |
| * tables on PPro+ CPUs. | |
| * | |
| * Copyright (C) 1999 Ingo Molnar <mingo@redhat.com> | |
| */ | |
| #define pte_ERROR(e) \ | |
| printk("%s:%d: bad pte %p(%08lx%08lx).\n", \ | |
| __FILE__, __LINE__, &(e), (e).pte_high, (e).pte_low) | |
| #define pmd_ERROR(e) \ | |
| printk("%s:%d: bad pmd %p(%016Lx).\n", \ | |
| __FILE__, __LINE__, &(e), pmd_val(e)) | |
| #define pgd_ERROR(e) \ | |
| printk("%s:%d: bad pgd %p(%016Lx).\n", \ | |
| __FILE__, __LINE__, &(e), pgd_val(e)) | |
| static inline int pud_none(pud_t pud) | |
| { | |
| return pud_val(pud) == 0; | |
| } | |
| static inline int pud_bad(pud_t pud) | |
| { | |
| return (pud_val(pud) & ~(PTE_MASK | _KERNPG_TABLE | _PAGE_USER)) != 0; | |
| } | |
| static inline int pud_present(pud_t pud) | |
| { | |
| return pud_val(pud) & _PAGE_PRESENT; | |
| } | |
| /* Rules for using set_pte: the pte being assigned *must* be | |
| * either not present or in a state where the hardware will | |
| * not attempt to update the pte. In places where this is | |
| * not possible, use pte_get_and_clear to obtain the old pte | |
| * value and then use set_pte to update it. -ben | |
| */ | |
| static inline void native_set_pte(pte_t *ptep, pte_t pte) | |
| { | |
| ptep->pte_high = pte.pte_high; | |
| smp_wmb(); | |
| ptep->pte_low = pte.pte_low; | |
| } | |
| /* | |
| * Since this is only called on user PTEs, and the page fault handler | |
| * must handle the already racy situation of simultaneous page faults, | |
| * we are justified in merely clearing the PTE present bit, followed | |
| * by a set. The ordering here is important. | |
| */ | |
| static inline void native_set_pte_present(struct mm_struct *mm, | |
| unsigned long addr, | |
| pte_t *ptep, pte_t pte) | |
| { | |
| ptep->pte_low = 0; | |
| smp_wmb(); | |
| ptep->pte_high = pte.pte_high; | |
| smp_wmb(); | |
| ptep->pte_low = pte.pte_low; | |
| } | |
| static inline void native_set_pte_atomic(pte_t *ptep, pte_t pte) | |
| { | |
| set_64bit((unsigned long long *)(ptep), native_pte_val(pte)); | |
| } | |
| static inline void native_set_pmd(pmd_t *pmdp, pmd_t pmd) | |
| { | |
| set_64bit((unsigned long long *)(pmdp), native_pmd_val(pmd)); | |
| } | |
| static inline void native_set_pud(pud_t *pudp, pud_t pud) | |
| { | |
| set_64bit((unsigned long long *)(pudp), native_pud_val(pud)); | |
| } | |
| /* | |
| * For PTEs and PDEs, we must clear the P-bit first when clearing a page table | |
| * entry, so clear the bottom half first and enforce ordering with a compiler | |
| * barrier. | |
| */ | |
| static inline void native_pte_clear(struct mm_struct *mm, unsigned long addr, | |
| pte_t *ptep) | |
| { | |
| ptep->pte_low = 0; | |
| smp_wmb(); | |
| ptep->pte_high = 0; | |
| } | |
| static inline void native_pmd_clear(pmd_t *pmd) | |
| { | |
| u32 *tmp = (u32 *)pmd; | |
| *tmp = 0; | |
| smp_wmb(); | |
| *(tmp + 1) = 0; | |
| } | |
| static inline void pud_clear(pud_t *pudp) | |
| { | |
| unsigned long pgd; | |
| set_pud(pudp, __pud(0)); | |
| /* | |
| * According to Intel App note "TLBs, Paging-Structure Caches, | |
| * and Their Invalidation", April 2007, document 317080-001, | |
| * section 8.1: in PAE mode we explicitly have to flush the | |
| * TLB via cr3 if the top-level pgd is changed... | |
| * | |
| * Make sure the pud entry we're updating is within the | |
| * current pgd to avoid unnecessary TLB flushes. | |
| */ | |
| pgd = read_cr3(); | |
| if (__pa(pudp) >= pgd && __pa(pudp) < | |
| (pgd + sizeof(pgd_t)*PTRS_PER_PGD)) | |
| write_cr3(pgd); | |
| } | |
| #define pud_page(pud) ((struct page *) __va(pud_val(pud) & PAGE_MASK)) | |
| #define pud_page_vaddr(pud) ((unsigned long) __va(pud_val(pud) & PAGE_MASK)) | |
| /* Find an entry in the second-level page table.. */ | |
| #define pmd_offset(pud, address) ((pmd_t *)pud_page(*(pud)) + \ | |
| pmd_index(address)) | |
| #ifdef CONFIG_SMP | |
| static inline pte_t native_ptep_get_and_clear(pte_t *ptep) | |
| { | |
| pte_t res; | |
| /* xchg acts as a barrier before the setting of the high bits */ | |
| res.pte_low = xchg(&ptep->pte_low, 0); | |
| res.pte_high = ptep->pte_high; | |
| ptep->pte_high = 0; | |
| return res; | |
| } | |
| #else | |
| #define native_ptep_get_and_clear(xp) native_local_ptep_get_and_clear(xp) | |
| #endif | |
| #define __HAVE_ARCH_PTE_SAME | |
| static inline int pte_same(pte_t a, pte_t b) | |
| { | |
| return a.pte_low == b.pte_low && a.pte_high == b.pte_high; | |
| } | |
| #define pte_page(x) pfn_to_page(pte_pfn(x)) | |
| static inline int pte_none(pte_t pte) | |
| { | |
| return !pte.pte_low && !pte.pte_high; | |
| } | |
| static inline unsigned long pte_pfn(pte_t pte) | |
| { | |
| return (pte_val(pte) & ~_PAGE_NX) >> PAGE_SHIFT; | |
| } | |
| /* | |
| * Bits 0, 6 and 7 are taken in the low part of the pte, | |
| * put the 32 bits of offset into the high part. | |
| */ | |
| #define pte_to_pgoff(pte) ((pte).pte_high) | |
| #define pgoff_to_pte(off) \ | |
| ((pte_t) { { .pte_low = _PAGE_FILE, .pte_high = (off) } }) | |
| #define PTE_FILE_MAX_BITS 32 | |
| /* Encode and de-code a swap entry */ | |
| #define __swp_type(x) (((x).val) & 0x1f) | |
| #define __swp_offset(x) ((x).val >> 5) | |
| #define __swp_entry(type, offset) ((swp_entry_t){(type) | (offset) << 5}) | |
| #define __pte_to_swp_entry(pte) ((swp_entry_t){ (pte).pte_high }) | |
| #define __swp_entry_to_pte(x) ((pte_t){ { .pte_high = (x).val } }) | |
| #endif /* _I386_PGTABLE_3LEVEL_H */ |