| MediaTek PMIC Wrapper Driver |
| |
| This document describes the binding for the MediaTek PMIC wrapper. |
| |
| On MediaTek SoCs the PMIC is connected via SPI. The SPI master interface |
| is not directly visible to the CPU, but only through the PMIC wrapper |
| inside the SoC. The communication between the SoC and the PMIC can |
| optionally be encrypted. Also a non standard Dual IO SPI mode can be |
| used to increase speed. |
| |
| IP Pairing |
| |
| on MT8135 the pins of some SoC internal peripherals can be on the PMIC. |
| The signals of these pins are routed over the SPI bus using the pwrap |
| bridge. In the binding description below the properties needed for bridging |
| are marked with "IP Pairing". These are optional on SoCs which do not support |
| IP Pairing |
| |
| Required properties in pwrap device node. |
| - compatible: |
| "mediatek,mt2701-pwrap" for MT2701/7623 SoCs |
| "mediatek,mt6797-pwrap" for MT6797 SoCs |
| "mediatek,mt7622-pwrap" for MT7622 SoCs |
| "mediatek,mt8135-pwrap" for MT8135 SoCs |
| "mediatek,mt8173-pwrap" for MT8173 SoCs |
| - interrupts: IRQ for pwrap in SOC |
| - reg-names: Must include the following entries: |
| "pwrap": Main registers base |
| "pwrap-bridge": bridge base (IP Pairing) |
| - reg: Must contain an entry for each entry in reg-names. |
| - reset-names: Must include the following entries: |
| "pwrap" |
| "pwrap-bridge" (IP Pairing) |
| - resets: Must contain an entry for each entry in reset-names. |
| - clock-names: Must include the following entries: |
| "spi": SPI bus clock |
| "wrap": Main module clock |
| - clocks: Must contain an entry for each entry in clock-names. |
| |
| Optional properities: |
| - pmic: Using either MediaTek PMIC MFD as the child device of pwrap |
| See the following for child node definitions: |
| Documentation/devicetree/bindings/mfd/mt6397.txt |
| or the regulator-only device as the child device of pwrap, such as MT6380. |
| See the following definitions for such kinds of devices. |
| Documentation/devicetree/bindings/regulator/mt6380-regulator.txt |
| |
| Example: |
| pwrap: pwrap@1000f000 { |
| compatible = "mediatek,mt8135-pwrap"; |
| reg = <0 0x1000f000 0 0x1000>, |
| <0 0x11017000 0 0x1000>; |
| reg-names = "pwrap", "pwrap-bridge"; |
| interrupts = <GIC_SPI 128 IRQ_TYPE_LEVEL_HIGH>; |
| resets = <&infracfg MT8135_INFRA_PMIC_WRAP_RST>, |
| <&pericfg MT8135_PERI_PWRAP_BRIDGE_SW_RST>; |
| reset-names = "pwrap", "pwrap-bridge"; |
| clocks = <&clk26m>, <&clk26m>; |
| clock-names = "spi", "wrap"; |
| |
| pmic { |
| compatible = "mediatek,mt6397"; |
| }; |
| }; |