| /* |
| * Copyright (C) 2004-2007 Atmel Corporation |
| * |
| * This program is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License version 2 as |
| * published by the Free Software Foundation. |
| */ |
| #include <linux/clk.h> |
| #include <linux/clockchips.h> |
| #include <linux/init.h> |
| #include <linux/interrupt.h> |
| #include <linux/irq.h> |
| #include <linux/kernel.h> |
| #include <linux/time.h> |
| |
| #include <asm/sysreg.h> |
| |
| #include <mach/pm.h> |
| |
| |
| static cycle_t read_cycle_count(void) |
| { |
| return (cycle_t)sysreg_read(COUNT); |
| } |
| |
| /* |
| * The architectural cycle count registers are a fine clocksource unless |
| * the system idle loop use sleep states like "idle": the CPU cycles |
| * measured by COUNT (and COMPARE) don't happen during sleep states. |
| * Their duration also changes if cpufreq changes the CPU clock rate. |
| * So we rate the clocksource using COUNT as very low quality. |
| */ |
| static struct clocksource counter = { |
| .name = "avr32_counter", |
| .rating = 50, |
| .read = read_cycle_count, |
| .mask = CLOCKSOURCE_MASK(32), |
| .shift = 16, |
| .flags = CLOCK_SOURCE_IS_CONTINUOUS, |
| }; |
| |
| static irqreturn_t timer_interrupt(int irq, void *dev_id) |
| { |
| struct clock_event_device *evdev = dev_id; |
| |
| if (unlikely(!(intc_get_pending(0) & 1))) |
| return IRQ_NONE; |
| |
| /* |
| * Disable the interrupt until the clockevent subsystem |
| * reprograms it. |
| */ |
| sysreg_write(COMPARE, 0); |
| |
| evdev->event_handler(evdev); |
| return IRQ_HANDLED; |
| } |
| |
| static struct irqaction timer_irqaction = { |
| .handler = timer_interrupt, |
| /* Oprofile uses the same irq as the timer, so allow it to be shared */ |
| .flags = IRQF_TIMER | IRQF_DISABLED | IRQF_SHARED, |
| .name = "avr32_comparator", |
| }; |
| |
| static int comparator_next_event(unsigned long delta, |
| struct clock_event_device *evdev) |
| { |
| unsigned long flags; |
| |
| raw_local_irq_save(flags); |
| |
| /* The time to read COUNT then update COMPARE must be less |
| * than the min_delta_ns value for this clockevent source. |
| */ |
| sysreg_write(COMPARE, (sysreg_read(COUNT) + delta) ? : 1); |
| |
| raw_local_irq_restore(flags); |
| |
| return 0; |
| } |
| |
| static void comparator_mode(enum clock_event_mode mode, |
| struct clock_event_device *evdev) |
| { |
| switch (mode) { |
| case CLOCK_EVT_MODE_ONESHOT: |
| pr_debug("%s: start\n", evdev->name); |
| /* FALLTHROUGH */ |
| case CLOCK_EVT_MODE_RESUME: |
| cpu_disable_idle_sleep(); |
| break; |
| case CLOCK_EVT_MODE_UNUSED: |
| case CLOCK_EVT_MODE_SHUTDOWN: |
| sysreg_write(COMPARE, 0); |
| pr_debug("%s: stop\n", evdev->name); |
| cpu_enable_idle_sleep(); |
| break; |
| default: |
| BUG(); |
| } |
| } |
| |
| static struct clock_event_device comparator = { |
| .name = "avr32_comparator", |
| .features = CLOCK_EVT_FEAT_ONESHOT, |
| .shift = 16, |
| .rating = 50, |
| .set_next_event = comparator_next_event, |
| .set_mode = comparator_mode, |
| }; |
| |
| void __init time_init(void) |
| { |
| unsigned long counter_hz; |
| int ret; |
| |
| xtime.tv_sec = mktime(2007, 1, 1, 0, 0, 0); |
| xtime.tv_nsec = 0; |
| |
| set_normalized_timespec(&wall_to_monotonic, |
| -xtime.tv_sec, -xtime.tv_nsec); |
| |
| /* figure rate for counter */ |
| counter_hz = clk_get_rate(boot_cpu_data.clk); |
| counter.mult = clocksource_hz2mult(counter_hz, counter.shift); |
| |
| ret = clocksource_register(&counter); |
| if (ret) |
| pr_debug("timer: could not register clocksource: %d\n", ret); |
| |
| /* setup COMPARE clockevent */ |
| comparator.mult = div_sc(counter_hz, NSEC_PER_SEC, comparator.shift); |
| comparator.max_delta_ns = clockevent_delta2ns((u32)~0, &comparator); |
| comparator.min_delta_ns = clockevent_delta2ns(50, &comparator) + 1; |
| comparator.cpumask = cpumask_of(0); |
| |
| sysreg_write(COMPARE, 0); |
| timer_irqaction.dev_id = &comparator; |
| |
| ret = setup_irq(0, &timer_irqaction); |
| if (ret) |
| pr_debug("timer: could not request IRQ 0: %d\n", ret); |
| else { |
| clockevents_register_device(&comparator); |
| |
| pr_info("%s: irq 0, %lu.%03lu MHz\n", comparator.name, |
| ((counter_hz + 500) / 1000) / 1000, |
| ((counter_hz + 500) / 1000) % 1000); |
| } |
| } |