| // SPDX-License-Identifier: GPL-2.0 |
| /* |
| * Renesas Emma Mobile 8250 driver |
| * |
| * Copyright (C) 2012 Magnus Damm |
| */ |
| |
| #include <linux/device.h> |
| #include <linux/io.h> |
| #include <linux/module.h> |
| #include <linux/mod_devicetable.h> |
| #include <linux/serial_8250.h> |
| #include <linux/serial_reg.h> |
| #include <linux/platform_device.h> |
| #include <linux/clk.h> |
| #include <linux/slab.h> |
| |
| #include "8250.h" |
| |
| #define UART_DLL_EM 9 |
| #define UART_DLM_EM 10 |
| |
| struct serial8250_em_priv { |
| struct clk *sclk; |
| int line; |
| }; |
| |
| static void serial8250_em_serial_out(struct uart_port *p, int offset, int value) |
| { |
| switch (offset) { |
| case UART_TX: /* TX @ 0x00 */ |
| writeb(value, p->membase); |
| break; |
| case UART_FCR: /* FCR @ 0x0c (+1) */ |
| case UART_LCR: /* LCR @ 0x10 (+1) */ |
| case UART_MCR: /* MCR @ 0x14 (+1) */ |
| case UART_SCR: /* SCR @ 0x20 (+1) */ |
| writel(value, p->membase + ((offset + 1) << 2)); |
| break; |
| case UART_IER: /* IER @ 0x04 */ |
| value &= 0x0f; /* only 4 valid bits - not Xscale */ |
| /* fall-through */ |
| case UART_DLL_EM: /* DLL @ 0x24 (+9) */ |
| case UART_DLM_EM: /* DLM @ 0x28 (+9) */ |
| writel(value, p->membase + (offset << 2)); |
| } |
| } |
| |
| static unsigned int serial8250_em_serial_in(struct uart_port *p, int offset) |
| { |
| switch (offset) { |
| case UART_RX: /* RX @ 0x00 */ |
| return readb(p->membase); |
| case UART_MCR: /* MCR @ 0x14 (+1) */ |
| case UART_LSR: /* LSR @ 0x18 (+1) */ |
| case UART_MSR: /* MSR @ 0x1c (+1) */ |
| case UART_SCR: /* SCR @ 0x20 (+1) */ |
| return readl(p->membase + ((offset + 1) << 2)); |
| case UART_IER: /* IER @ 0x04 */ |
| case UART_IIR: /* IIR @ 0x08 */ |
| case UART_DLL_EM: /* DLL @ 0x24 (+9) */ |
| case UART_DLM_EM: /* DLM @ 0x28 (+9) */ |
| return readl(p->membase + (offset << 2)); |
| } |
| return 0; |
| } |
| |
| static int serial8250_em_serial_dl_read(struct uart_8250_port *up) |
| { |
| return serial_in(up, UART_DLL_EM) | serial_in(up, UART_DLM_EM) << 8; |
| } |
| |
| static void serial8250_em_serial_dl_write(struct uart_8250_port *up, int value) |
| { |
| serial_out(up, UART_DLL_EM, value & 0xff); |
| serial_out(up, UART_DLM_EM, value >> 8 & 0xff); |
| } |
| |
| static int serial8250_em_probe(struct platform_device *pdev) |
| { |
| struct resource *regs = platform_get_resource(pdev, IORESOURCE_MEM, 0); |
| struct resource *irq = platform_get_resource(pdev, IORESOURCE_IRQ, 0); |
| struct serial8250_em_priv *priv; |
| struct uart_8250_port up; |
| int ret; |
| |
| if (!regs || !irq) { |
| dev_err(&pdev->dev, "missing registers or irq\n"); |
| return -EINVAL; |
| } |
| |
| priv = devm_kzalloc(&pdev->dev, sizeof(*priv), GFP_KERNEL); |
| if (!priv) |
| return -ENOMEM; |
| |
| priv->sclk = devm_clk_get(&pdev->dev, "sclk"); |
| if (IS_ERR(priv->sclk)) { |
| dev_err(&pdev->dev, "unable to get clock\n"); |
| return PTR_ERR(priv->sclk); |
| } |
| |
| memset(&up, 0, sizeof(up)); |
| up.port.mapbase = regs->start; |
| up.port.irq = irq->start; |
| up.port.type = PORT_UNKNOWN; |
| up.port.flags = UPF_BOOT_AUTOCONF | UPF_FIXED_PORT | UPF_IOREMAP; |
| up.port.dev = &pdev->dev; |
| up.port.private_data = priv; |
| |
| clk_prepare_enable(priv->sclk); |
| up.port.uartclk = clk_get_rate(priv->sclk); |
| |
| up.port.iotype = UPIO_MEM32; |
| up.port.serial_in = serial8250_em_serial_in; |
| up.port.serial_out = serial8250_em_serial_out; |
| up.dl_read = serial8250_em_serial_dl_read; |
| up.dl_write = serial8250_em_serial_dl_write; |
| |
| ret = serial8250_register_8250_port(&up); |
| if (ret < 0) { |
| dev_err(&pdev->dev, "unable to register 8250 port\n"); |
| clk_disable_unprepare(priv->sclk); |
| return ret; |
| } |
| |
| priv->line = ret; |
| platform_set_drvdata(pdev, priv); |
| return 0; |
| } |
| |
| static int serial8250_em_remove(struct platform_device *pdev) |
| { |
| struct serial8250_em_priv *priv = platform_get_drvdata(pdev); |
| |
| serial8250_unregister_port(priv->line); |
| clk_disable_unprepare(priv->sclk); |
| return 0; |
| } |
| |
| static const struct of_device_id serial8250_em_dt_ids[] = { |
| { .compatible = "renesas,em-uart", }, |
| {}, |
| }; |
| MODULE_DEVICE_TABLE(of, serial8250_em_dt_ids); |
| |
| static struct platform_driver serial8250_em_platform_driver = { |
| .driver = { |
| .name = "serial8250-em", |
| .of_match_table = serial8250_em_dt_ids, |
| }, |
| .probe = serial8250_em_probe, |
| .remove = serial8250_em_remove, |
| }; |
| |
| module_platform_driver(serial8250_em_platform_driver); |
| |
| MODULE_AUTHOR("Magnus Damm"); |
| MODULE_DESCRIPTION("Renesas Emma Mobile 8250 Driver"); |
| MODULE_LICENSE("GPL v2"); |