| /* | |
| * DTS file for all SPEAr1340 SoCs | |
| * | |
| * Copyright 2012 Viresh Kumar <vireshk@kernel.org> | |
| * | |
| * The code contained herein is licensed under the GNU General Public | |
| * License. You may obtain a copy of the GNU General Public License | |
| * Version 2 or later at the following locations: | |
| * | |
| * http://www.opensource.org/licenses/gpl-license.html | |
| * http://www.gnu.org/copyleft/gpl.html | |
| */ | |
| /include/ "spear13xx.dtsi" | |
| / { | |
| compatible = "st,spear1340"; | |
| ahb { | |
| spics: spics@e0700000{ | |
| compatible = "st,spear-spics-gpio"; | |
| reg = <0xe0700000 0x1000>; | |
| st-spics,peripcfg-reg = <0x42c>; | |
| st-spics,sw-enable-bit = <21>; | |
| st-spics,cs-value-bit = <20>; | |
| st-spics,cs-enable-mask = <3>; | |
| st-spics,cs-enable-shift = <18>; | |
| gpio-controller; | |
| #gpio-cells = <2>; | |
| status = "disabled"; | |
| }; | |
| miphy0: miphy@eb800000 { | |
| compatible = "st,spear1340-miphy"; | |
| reg = <0xeb800000 0x4000>; | |
| misc = <&misc>; | |
| #phy-cells = <1>; | |
| status = "disabled"; | |
| }; | |
| ahci0: ahci@b1000000 { | |
| compatible = "snps,spear-ahci"; | |
| reg = <0xb1000000 0x10000>; | |
| interrupts = <0 72 0x4>; | |
| phys = <&miphy0 0>; | |
| phy-names = "sata-phy"; | |
| status = "disabled"; | |
| }; | |
| pcie0: pcie@b1000000 { | |
| compatible = "st,spear1340-pcie", "snps,dw-pcie"; | |
| reg = <0xb1000000 0x4000>, <0x80000000 0x20000>; | |
| reg-names = "dbi", "config"; | |
| interrupts = <0 68 0x4>; | |
| interrupt-map-mask = <0 0 0 0>; | |
| interrupt-map = <0x0 0 &gic 0 68 0x4>; | |
| num-lanes = <1>; | |
| phys = <&miphy0 1>; | |
| phy-names = "pcie-phy"; | |
| #address-cells = <3>; | |
| #size-cells = <2>; | |
| device_type = "pci"; | |
| ranges = <0x81000000 0 0 0x80020000 0 0x00010000 /* downstream I/O */ | |
| 0x82000000 0 0x80030000 0xc0030000 0 0x0ffd0000>; /* non-prefetchable memory */ | |
| bus-range = <0x00 0xff>; | |
| status = "disabled"; | |
| }; | |
| i2s-play@b2400000 { | |
| compatible = "snps,designware-i2s"; | |
| reg = <0xb2400000 0x10000>; | |
| interrupt-names = "play_irq"; | |
| interrupts = <0 98 0x4 | |
| 0 99 0x4>; | |
| play; | |
| channel = <8>; | |
| status = "disabled"; | |
| }; | |
| i2s-rec@b2000000 { | |
| compatible = "snps,designware-i2s"; | |
| reg = <0xb2000000 0x10000>; | |
| interrupt-names = "record_irq"; | |
| interrupts = <0 100 0x4 | |
| 0 101 0x4>; | |
| record; | |
| channel = <8>; | |
| status = "disabled"; | |
| }; | |
| pinmux: pinmux@e0700000 { | |
| compatible = "st,spear1340-pinmux"; | |
| reg = <0xe0700000 0x1000>; | |
| #gpio-range-cells = <3>; | |
| }; | |
| pwm: pwm@e0180000 { | |
| compatible ="st,spear13xx-pwm"; | |
| reg = <0xe0180000 0x1000>; | |
| #pwm-cells = <2>; | |
| status = "disabled"; | |
| }; | |
| spdif-in@d0100000 { | |
| compatible = "st,spdif-in"; | |
| reg = < 0xd0100000 0x20000 | |
| 0xd0110000 0x10000 >; | |
| interrupts = <0 84 0x4>; | |
| status = "disabled"; | |
| }; | |
| spdif-out@d0000000 { | |
| compatible = "st,spdif-out"; | |
| reg = <0xd0000000 0x20000>; | |
| interrupts = <0 85 0x4>; | |
| status = "disabled"; | |
| }; | |
| spi1: spi@5d400000 { | |
| compatible = "arm,pl022", "arm,primecell"; | |
| reg = <0x5d400000 0x1000>; | |
| #address-cells = <1>; | |
| #size-cells = <0>; | |
| interrupts = <0 99 0x4>; | |
| status = "disabled"; | |
| }; | |
| apb { | |
| i2c1: i2c@b4000000 { | |
| #address-cells = <1>; | |
| #size-cells = <0>; | |
| compatible = "snps,designware-i2c"; | |
| reg = <0xb4000000 0x1000>; | |
| interrupts = <0 104 0x4>; | |
| write-16bit; | |
| status = "disabled"; | |
| }; | |
| serial@b4100000 { | |
| compatible = "arm,pl011", "arm,primecell"; | |
| reg = <0xb4100000 0x1000>; | |
| interrupts = <0 105 0x4>; | |
| status = "disabled"; | |
| dmas = <&dwdma0 12 0 1>, | |
| <&dwdma0 13 1 0>; | |
| dma-names = "tx", "rx"; | |
| }; | |
| thermal@e07008c4 { | |
| st,thermal-flags = <0x2a00>; | |
| }; | |
| gpiopinctrl: gpio@e2800000 { | |
| compatible = "st,spear-plgpio"; | |
| reg = <0xe2800000 0x1000>; | |
| interrupts = <0 107 0x4>; | |
| #interrupt-cells = <1>; | |
| interrupt-controller; | |
| gpio-controller; | |
| #gpio-cells = <2>; | |
| gpio-ranges = <&pinmux 0 0 252>; | |
| status = "disabled"; | |
| st-plgpio,ngpio = <250>; | |
| st-plgpio,wdata-reg = <0x40>; | |
| st-plgpio,dir-reg = <0x00>; | |
| st-plgpio,ie-reg = <0x80>; | |
| st-plgpio,rdata-reg = <0x20>; | |
| st-plgpio,mis-reg = <0xa0>; | |
| st-plgpio,eit-reg = <0x60>; | |
| }; | |
| }; | |
| }; | |
| }; |