| /* |
| * ecc.h: Definitions and defines for the external cache/memory |
| * controller on the sun4m. |
| * |
| * Copyright (C) 1995 David S. Miller (davem@caip.rutgers.edu) |
| */ |
| |
| #ifndef _SPARC_ECC_H |
| #define _SPARC_ECC_H |
| |
| /* These registers are accessed through the SRMMU passthrough ASI 0x20 */ |
| #define ECC_ENABLE 0x00000000 /* ECC enable register */ |
| #define ECC_FSTATUS 0x00000008 /* ECC fault status register */ |
| #define ECC_FADDR 0x00000010 /* ECC fault address register */ |
| #define ECC_DIGNOSTIC 0x00000018 /* ECC diagnostics register */ |
| #define ECC_MBAENAB 0x00000020 /* MBus arbiter enable register */ |
| #define ECC_DMESG 0x00001000 /* Diagnostic message passing area */ |
| |
| /* ECC MBus Arbiter Enable register: |
| * |
| * ---------------------------------------- |
| * | |SBUS|MOD3|MOD2|MOD1|RSV| |
| * ---------------------------------------- |
| * 31 5 4 3 2 1 0 |
| * |
| * SBUS: Enable MBus Arbiter on the SBus 0=off 1=on |
| * MOD3: Enable MBus Arbiter on MBus module 3 0=off 1=on |
| * MOD2: Enable MBus Arbiter on MBus module 2 0=off 1=on |
| * MOD1: Enable MBus Arbiter on MBus module 1 0=off 1=on |
| */ |
| |
| #define ECC_MBAE_SBUS 0x00000010 |
| #define ECC_MBAE_MOD3 0x00000008 |
| #define ECC_MBAE_MOD2 0x00000004 |
| #define ECC_MBAE_MOD1 0x00000002 |
| |
| /* ECC Fault Control Register layout: |
| * |
| * ----------------------------- |
| * | RESV | ECHECK | EINT | |
| * ----------------------------- |
| * 31 2 1 0 |
| * |
| * ECHECK: Enable ECC checking. 0=off 1=on |
| * EINT: Enable Interrupts for correctable errors. 0=off 1=on |
| */ |
| #define ECC_FCR_CHECK 0x00000002 |
| #define ECC_FCR_INTENAB 0x00000001 |
| |
| /* ECC Fault Address Register Zero layout: |
| * |
| * ----------------------------------------------------- |
| * | MID | S | RSV | VA | BM |AT| C| SZ |TYP| PADDR | |
| * ----------------------------------------------------- |
| * 31-28 27 26-22 21-14 13 12 11 10-8 7-4 3-0 |
| * |
| * MID: ModuleID of the faulting processor. ie. who did it? |
| * S: Supervisor/Privileged access? 0=no 1=yes |
| * VA: Bits 19-12 of the virtual faulting address, these are the |
| * superset bits in the virtual cache and can be used for |
| * a flush operation if necessary. |
| * BM: Boot mode? 0=no 1=yes This is just like the SRMMU boot |
| * mode bit. |
| * AT: Did this fault happen during an atomic instruction? 0=no |
| * 1=yes. This means either an 'ldstub' or 'swap' instruction |
| * was in progress (but not finished) when this fault happened. |
| * This indicated whether the bus was locked when the fault |
| * occurred. |
| * C: Did the pte for this access indicate that it was cacheable? |
| * 0=no 1=yes |
| * SZ: The size of the transaction. |
| * TYP: The transaction type. |
| * PADDR: Bits 35-32 of the physical address for the fault. |
| */ |
| #define ECC_FADDR0_MIDMASK 0xf0000000 |
| #define ECC_FADDR0_S 0x08000000 |
| #define ECC_FADDR0_VADDR 0x003fc000 |
| #define ECC_FADDR0_BMODE 0x00002000 |
| #define ECC_FADDR0_ATOMIC 0x00001000 |
| #define ECC_FADDR0_CACHE 0x00000800 |
| #define ECC_FADDR0_SIZE 0x00000700 |
| #define ECC_FADDR0_TYPE 0x000000f0 |
| #define ECC_FADDR0_PADDR 0x0000000f |
| |
| /* ECC Fault Address Register One layout: |
| * |
| * ------------------------------------- |
| * | Physical Address 31-0 | |
| * ------------------------------------- |
| * 31 0 |
| * |
| * You get the upper 4 bits of the physical address from the |
| * PADDR field in ECC Fault Address Zero register. |
| */ |
| |
| /* ECC Fault Status Register layout: |
| * |
| * ---------------------------------------------- |
| * | RESV|C2E|MULT|SYNDROME|DWORD|UNC|TIMEO|BS|C| |
| * ---------------------------------------------- |
| * 31-18 17 16 15-8 7-4 3 2 1 0 |
| * |
| * C2E: A C2 graphics error occurred. 0=no 1=yes (SS10 only) |
| * MULT: Multiple errors occurred ;-O 0=no 1=prom_panic(yes) |
| * SYNDROME: Controller is mentally unstable. |
| * DWORD: |
| * UNC: Uncorrectable error. 0=no 1=yes |
| * TIMEO: Timeout occurred. 0=no 1=yes |
| * BS: C2 graphics bad slot access. 0=no 1=yes (SS10 only) |
| * C: Correctable error? 0=no 1=yes |
| */ |
| |
| #define ECC_FSR_C2ERR 0x00020000 |
| #define ECC_FSR_MULT 0x00010000 |
| #define ECC_FSR_SYND 0x0000ff00 |
| #define ECC_FSR_DWORD 0x000000f0 |
| #define ECC_FSR_UNC 0x00000008 |
| #define ECC_FSR_TIMEO 0x00000004 |
| #define ECC_FSR_BADSLOT 0x00000002 |
| #define ECC_FSR_C 0x00000001 |
| |
| #endif /* !(_SPARC_ECC_H) */ |
