| * Devantech SRF04 ultrasonic range finder | |
| Bit-banging driver using two GPIOs | |
| Required properties: | |
| - compatible: Should be "devantech,srf04" | |
| - trig-gpios: Definition of the GPIO for the triggering (output) | |
| This GPIO is set for about 10 us by the driver to tell the | |
| device it should initiate the measurement cycle. | |
| - echo-gpios: Definition of the GPIO for the echo (input) | |
| This GPIO is set by the device as soon as an ultrasonic | |
| burst is sent out and reset when the first echo is | |
| received. | |
| Thus this GPIO is set while the ultrasonic waves are doing | |
| one round trip. | |
| It needs to be an GPIO which is able to deliver an | |
| interrupt because the time between two interrupts is | |
| measured in the driver. | |
| See Documentation/devicetree/bindings/gpio/gpio.txt for | |
| information on how to specify a consumer gpio. | |
| Example: | |
| srf04@0 { | |
| compatible = "devantech,srf04"; | |
| trig-gpios = <&gpio1 15 GPIO_ACTIVE_HIGH>; | |
| echo-gpios = <&gpio2 6 GPIO_ACTIVE_HIGH>; | |
| }; |