| Qualcomm Technologies Inc. adreno/snapdragon eDP output | |
| Required properties: | |
| - compatible: | |
| * "qcom,mdss-edp" | |
| - reg: Physical base address and length of the registers of controller and PLL | |
| - reg-names: The names of register regions. The following regions are required: | |
| * "edp" | |
| * "pll_base" | |
| - interrupts: The interrupt signal from the eDP block. | |
| - power-domains: Should be <&mmcc MDSS_GDSC>. | |
| - clocks: device clocks | |
| See Documentation/devicetree/bindings/clock/clock-bindings.txt for details. | |
| - clock-names: the following clocks are required: | |
| * "core" | |
| * "iface" | |
| * "mdp_core" | |
| * "pixel" | |
| * "link" | |
| - #clock-cells: The value should be 1. | |
| - vdda-supply: phandle to vdda regulator device node | |
| - lvl-vdd-supply: phandle to regulator device node which is used to supply power | |
| to HPD receiving chip | |
| - panel-en-gpios: GPIO pin to supply power to panel. | |
| - panel-hpd-gpios: GPIO pin used for eDP hpd. | |
| Example: | |
| mdss_edp: qcom,mdss_edp@fd923400 { | |
| compatible = "qcom,mdss-edp"; | |
| reg-names = | |
| "edp", | |
| "pll_base"; | |
| reg = <0xfd923400 0x700>, | |
| <0xfd923a00 0xd4>; | |
| interrupt-parent = <&mdss_mdp>; | |
| interrupts = <12 0>; | |
| power-domains = <&mmcc MDSS_GDSC>; | |
| clock-names = | |
| "core", | |
| "pixel", | |
| "iface", | |
| "link", | |
| "mdp_core"; | |
| clocks = | |
| <&mmcc MDSS_EDPAUX_CLK>, | |
| <&mmcc MDSS_EDPPIXEL_CLK>, | |
| <&mmcc MDSS_AHB_CLK>, | |
| <&mmcc MDSS_EDPLINK_CLK>, | |
| <&mmcc MDSS_MDP_CLK>; | |
| #clock-cells = <1>; | |
| vdda-supply = <&pma8084_l12>; | |
| lvl-vdd-supply = <&lvl_vreg>; | |
| panel-en-gpios = <&tlmm 137 0>; | |
| panel-hpd-gpios = <&tlmm 103 0>; | |
| }; |