| Device-Tree bindings for ST IRB IP |
| |
| Required properties: |
| - compatible: Should contain "st,comms-irb". |
| - reg: Base physical address of the controller and length of memory |
| mapped region. |
| - interrupts: interrupt-specifier for the sole interrupt generated by |
| the device. The interrupt specifier format depends on the interrupt |
| controller parent. |
| - rx-mode: can be "infrared" or "uhf". This property specifies the L1 |
| protocol used for receiving remote control signals. rx-mode should |
| be present iff the rx pins are wired up. |
| - tx-mode: should be "infrared". This property specifies the L1 |
| protocol used for transmitting remote control signals. tx-mode should |
| be present iff the tx pins are wired up. |
| |
| Optional properties: |
| - pinctrl-names, pinctrl-0: the pincontrol settings to configure muxing |
| properly for IRB pins. |
| - clocks : phandle with clock-specifier pair for IRB. |
| |
| Example node: |
| |
| rc: rc@fe518000 { |
| compatible = "st,comms-irb"; |
| reg = <0xfe518000 0x234>; |
| interrupts = <0 203 0>; |
| rx-mode = "infrared"; |
| }; |
