| Legacy Freescale RA169Z20 adapter card for Seiko 43WVFIG panel, driver bindings |
| |
| This is an adapter card made for the 4.3", 800x480, LCD panel Seiko 43WVFIG. |
| The LCD panel is a 24bit DPI bus, while the adapter card has two ports: |
| 18-bit and 24-bit data input. For the 18-bit data input, the adapter card |
| is demuxing some of the data lines, in order to feed all of the 24 lines |
| needed by the LCD. |
| |
| Required properties: |
| - compatible: "nxp,seiko-43wvfig" |
| - bus_mode: must be one of <18> or <24>, depending on the input port |
| used (18-bit or 24-bit) |
| - port: input and output port nodes with endpoint definitions as |
| defined in Documentation/devicetree/bindings/graph.txt; |
| the input port should be connected to an lcd controller |
| while the output port should be connected to the Seiko |
| 43wvfig LCD panel |
| |
| Example: |
| seiko_adapter: seiko-adapter { |
| #address-cells = <1>; |
| #size-cells = <0>; |
| compatible = "nxp,seiko-43wvfig"; |
| bus_mode = <18>; |
| |
| port@0 { |
| reg = <0>; |
| adapter_in: endpoint { |
| remote-endpoint = <&lcdif_out>; |
| }; |
| }; |
| port@1 { |
| reg = <1>; |
| adapter_out: endpoint { |
| remote-endpoint = <&panel_in>; |
| }; |
| }; |
| }; |
| |
| - |
