| // SPDX-License-Identifier: GPL-2.0 |
| /* |
| * Driver for the NXP ISP1760 chip |
| * |
| * Copyright 2014 Laurent Pinchart |
| * Copyright 2007 Sebastian Siewior |
| * |
| * Contacts: |
| * Sebastian Siewior <bigeasy@linutronix.de> |
| * Laurent Pinchart <laurent.pinchart@ideasonboard.com> |
| * |
| * This program is free software; you can redistribute it and/or |
| * modify it under the terms of the GNU General Public License |
| * version 2 as published by the Free Software Foundation. |
| */ |
| |
| #include <linux/delay.h> |
| #include <linux/gpio/consumer.h> |
| #include <linux/io.h> |
| #include <linux/kernel.h> |
| #include <linux/module.h> |
| #include <linux/slab.h> |
| #include <linux/usb.h> |
| |
| #include "isp1760-core.h" |
| #include "isp1760-hcd.h" |
| #include "isp1760-regs.h" |
| #include "isp1760-udc.h" |
| |
| static void isp1760_init_core(struct isp1760_device *isp) |
| { |
| u32 otgctrl; |
| u32 hwmode; |
| |
| /* Low-level chip reset */ |
| if (isp->rst_gpio) { |
| gpiod_set_value_cansleep(isp->rst_gpio, 1); |
| mdelay(50); |
| gpiod_set_value_cansleep(isp->rst_gpio, 0); |
| } |
| |
| /* |
| * Reset the host controller, including the CPU interface |
| * configuration. |
| */ |
| isp1760_write32(isp->regs, HC_RESET_REG, SW_RESET_RESET_ALL); |
| msleep(100); |
| |
| /* Setup HW Mode Control: This assumes a level active-low interrupt */ |
| hwmode = HW_DATA_BUS_32BIT; |
| |
| if (isp->devflags & ISP1760_FLAG_BUS_WIDTH_16) |
| hwmode &= ~HW_DATA_BUS_32BIT; |
| if (isp->devflags & ISP1760_FLAG_ANALOG_OC) |
| hwmode |= HW_ANA_DIGI_OC; |
| if (isp->devflags & ISP1760_FLAG_DACK_POL_HIGH) |
| hwmode |= HW_DACK_POL_HIGH; |
| if (isp->devflags & ISP1760_FLAG_DREQ_POL_HIGH) |
| hwmode |= HW_DREQ_POL_HIGH; |
| if (isp->devflags & ISP1760_FLAG_INTR_POL_HIGH) |
| hwmode |= HW_INTR_HIGH_ACT; |
| if (isp->devflags & ISP1760_FLAG_INTR_EDGE_TRIG) |
| hwmode |= HW_INTR_EDGE_TRIG; |
| |
| /* |
| * The ISP1761 has a dedicated DC IRQ line but supports sharing the HC |
| * IRQ line for both the host and device controllers. Hardcode IRQ |
| * sharing for now and disable the DC interrupts globally to avoid |
| * spurious interrupts during HCD registration. |
| */ |
| if (isp->devflags & ISP1760_FLAG_ISP1761) { |
| isp1760_write32(isp->regs, DC_MODE, 0); |
| hwmode |= HW_COMN_IRQ; |
| } |
| |
| /* |
| * We have to set this first in case we're in 16-bit mode. |
| * Write it twice to ensure correct upper bits if switching |
| * to 16-bit mode. |
| */ |
| isp1760_write32(isp->regs, HC_HW_MODE_CTRL, hwmode); |
| isp1760_write32(isp->regs, HC_HW_MODE_CTRL, hwmode); |
| |
| /* |
| * PORT 1 Control register of the ISP1760 is the OTG control register |
| * on ISP1761. |
| * |
| * TODO: Really support OTG. For now we configure port 1 in device mode |
| * when OTG is requested. |
| */ |
| if ((isp->devflags & ISP1760_FLAG_ISP1761) && |
| (isp->devflags & ISP1760_FLAG_OTG_EN)) |
| otgctrl = ((HW_DM_PULLDOWN | HW_DP_PULLDOWN) << 16) |
| | HW_OTG_DISABLE; |
| else |
| otgctrl = (HW_SW_SEL_HC_DC << 16) |
| | (HW_VBUS_DRV | HW_SEL_CP_EXT); |
| |
| isp1760_write32(isp->regs, HC_PORT1_CTRL, otgctrl); |
| |
| dev_info(isp->dev, "bus width: %u, oc: %s\n", |
| isp->devflags & ISP1760_FLAG_BUS_WIDTH_16 ? 16 : 32, |
| isp->devflags & ISP1760_FLAG_ANALOG_OC ? "analog" : "digital"); |
| } |
| |
| void isp1760_set_pullup(struct isp1760_device *isp, bool enable) |
| { |
| isp1760_write32(isp->regs, HW_OTG_CTRL_SET, |
| enable ? HW_DP_PULLUP : HW_DP_PULLUP << 16); |
| } |
| |
| int isp1760_register(struct resource *mem, int irq, unsigned long irqflags, |
| struct device *dev, unsigned int devflags) |
| { |
| struct isp1760_device *isp; |
| bool udc_disabled = !(devflags & ISP1760_FLAG_ISP1761); |
| int ret; |
| |
| /* |
| * If neither the HCD not the UDC is enabled return an error, as no |
| * device would be registered. |
| */ |
| if ((!IS_ENABLED(CONFIG_USB_ISP1760_HCD) || usb_disabled()) && |
| (!IS_ENABLED(CONFIG_USB_ISP1761_UDC) || udc_disabled)) |
| return -ENODEV; |
| |
| /* prevent usb-core allocating DMA pages */ |
| dev->dma_mask = NULL; |
| |
| isp = devm_kzalloc(dev, sizeof(*isp), GFP_KERNEL); |
| if (!isp) |
| return -ENOMEM; |
| |
| isp->dev = dev; |
| isp->devflags = devflags; |
| |
| isp->rst_gpio = devm_gpiod_get_optional(dev, NULL, GPIOD_OUT_HIGH); |
| if (IS_ERR(isp->rst_gpio)) |
| return PTR_ERR(isp->rst_gpio); |
| |
| isp->regs = devm_ioremap_resource(dev, mem); |
| if (IS_ERR(isp->regs)) |
| return PTR_ERR(isp->regs); |
| |
| isp1760_init_core(isp); |
| |
| if (IS_ENABLED(CONFIG_USB_ISP1760_HCD) && !usb_disabled()) { |
| ret = isp1760_hcd_register(&isp->hcd, isp->regs, mem, irq, |
| irqflags | IRQF_SHARED, dev); |
| if (ret < 0) |
| return ret; |
| } |
| |
| if (IS_ENABLED(CONFIG_USB_ISP1761_UDC) && !udc_disabled) { |
| ret = isp1760_udc_register(isp, irq, irqflags); |
| if (ret < 0) { |
| isp1760_hcd_unregister(&isp->hcd); |
| return ret; |
| } |
| } |
| |
| dev_set_drvdata(dev, isp); |
| |
| return 0; |
| } |
| |
| void isp1760_unregister(struct device *dev) |
| { |
| struct isp1760_device *isp = dev_get_drvdata(dev); |
| |
| isp1760_udc_unregister(isp); |
| isp1760_hcd_unregister(&isp->hcd); |
| } |
| |
| MODULE_DESCRIPTION("Driver for the ISP1760 USB-controller from NXP"); |
| MODULE_AUTHOR("Sebastian Siewior <bigeasy@linuxtronix.de>"); |
| MODULE_LICENSE("GPL v2"); |