MLK-25349-1 dt-bindings: imx6q-pcie: add one regulator used to power up pcie phy
Both 1.8v and 3.3v power supplies can be used by i.MX8MQ PCIe PHY.
In default, the PCIE_VPH voltage is suggested to be 1.8v refer to data
sheet. When PCIE_VPH is supplied by 3.3v in the HW schematic design,
the VREG_BYPASS bits of GPR registers should be cleared from default
value 1b'1 to 1b'0. Thus, the internal 3v3 to 1v8 translator would be
turned on.
Signed-off-by: Richard Zhu <hongxing.zhu@nxp.com>
Reviewed-by: Jun Li <jun.li@nxp.com>
Change-Id: I54ba0977f6c953493a5e7506c3c1fbdf75a55ec9
diff --git a/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.txt b/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.txt
index 45deda1..5ab5c2f 100644
--- a/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.txt
+++ b/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.txt
@@ -43,6 +43,9 @@
The regulator will be enabled when initializing the PCIe host and
disabled either as part of the init process or when shutting down the
host.
+- vph-supply: Should specify the regulator in charge of VPH one of the three
+ PCIe PHY powers. This regulator can be supplied by both 1.8v and 3.3v voltage
+ supplies. Might be used to distinguish different HW board designs.
Additional required properties for imx6sx-pcie:
- clock names: Must include the following additional entries:
