| # |
| # ARC EMAC network device configuration |
| # |
| |
| config NET_VENDOR_ARC |
| bool "ARC devices" |
| default y |
| ---help--- |
| If you have a network (Ethernet) card belonging to this class, say Y. |
| |
| Note that the answer to this question doesn't directly affect the |
| kernel: saying N will just cause the configurator to skip all |
| the questions about ARC cards. If you say Y, you will be asked for |
| your specific card in the following questions. |
| |
| if NET_VENDOR_ARC |
| |
| config ARC_EMAC_CORE |
| tristate |
| depends on ARC || ARCH_ROCKCHIP || COMPILE_TEST |
| select MII |
| select PHYLIB |
| |
| config ARC_EMAC |
| tristate "ARC EMAC support" |
| select ARC_EMAC_CORE |
| depends on OF_IRQ && OF_NET && HAS_DMA && (ARC || COMPILE_TEST) |
| ---help--- |
| On some legacy ARC (Synopsys) FPGA boards such as ARCAngel4/ML50x |
| non-standard on-chip ethernet device ARC EMAC 10/100 is used. |
| Say Y here if you have such a board. If unsure, say N. |
| |
| config EMAC_ROCKCHIP |
| tristate "Rockchip EMAC support" |
| select ARC_EMAC_CORE |
| depends on OF_IRQ && OF_NET && REGULATOR && HAS_DMA && (ARCH_ROCKCHIP || COMPILE_TEST) |
| ---help--- |
| Support for Rockchip RK3036/RK3066/RK3188 EMAC ethernet controllers. |
| This selects Rockchip SoC glue layer support for the |
| emac device driver. This driver is used for RK3036/RK3066/RK3188 |
| EMAC ethernet controller. |
| |
| endif # NET_VENDOR_ARC |
