blob: 31d6eeec0cef7beb3fcd60d2052b0aa16155b4d8 [file] [log] [blame]
/*
* U-Boot - main board file
*
* Copyright (c) 2005-2008 Analog Devices Inc.
*
* Licensed under the GPL-2 or later.
*/
#include <common.h>
#include <config.h>
#include <command.h>
#include <netdev.h>
#include <asm/blackfin.h>
#include <asm/gpio.h>
#include <asm/portmux.h>
#include <asm/sdh.h>
DECLARE_GLOBAL_DATA_PTR;
int checkboard(void)
{
printf("Board: ADI BF548 EZ-Kit board\n");
printf(" Support: http://blackfin.uclinux.org/\n");
return 0;
}
int board_early_init_f(void)
{
/* Set async addr lines as peripheral */
const unsigned short pins[] = {
P_A4, P_A5, P_A6, P_A7, P_A8, P_A9, P_A10, P_A11, P_A12,
P_A13, P_A14, P_A15, P_A16, P_A17, P_A18, P_A19, P_A20,
P_A21, P_A22, P_A23, P_A24, 0
};
return peripheral_request_list(pins, "async");
}
#ifdef CONFIG_SMC911X
int board_eth_init(bd_t *bis)
{
return smc911x_initialize(0, CONFIG_SMC911X_BASE);
}
#endif
#ifdef CONFIG_BFIN_SDH
int board_mmc_init(bd_t *bis)
{
return bfin_mmc_init(bis);
}
#endif
#ifdef CONFIG_USB_BLACKFIN
void board_musb_init(void)
{
/*
* Rev 1.0 BF549 EZ-KITs require PE7 to be high for both device
* and OTG host modes, while rev 1.1 and greater require PE7 to
* be low for device mode and high for host mode. We set it high
* here because we are in host mode.
*/
gpio_request(GPIO_PE7, "musb-vbus");
gpio_direction_output(GPIO_PE7, 1);
}
#endif