| How to use U-Boot on PHYTEC phyBOARD-i.MX6UL-Segin |
| -------------------------------------------------- |
| |
| - Configure and build U-Boot for phyCORE-i.MX6UL: |
| |
| $ make mrproper |
| $ make phycore_pcl063_defconfig |
| $ make |
| |
| This will generate SPL and u-boot-dtb.img images. |
| |
| - The SPL and u-boot-dtb.img images need to be flashed into the micro SD card: |
| |
| $ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync |
| $ sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync |
| |
| - Jumper settings: |
| |
| JP1: Open: Boot from NAND |
| Closed: Boot from SD/MMC1 |
| |
| - Connect the Serial cable to UART0 and the PC for the console. |
| |
| - Insert the micro SD card in the board and power it up. |
| |
| - U-Boot messages should come up. |
