if ARCH_IMX8

config RECOVER_SPL_DATA_SECTION
	bool
	help
	  Save SPL DATA section for cold boot, restore at warm boot

config IMX_SMMU
	bool "Enable SMMU on i.MX8"
	help
	  Enable the SMMU for peripherals on i.MX8

config AHAB_BOOT
	bool "Support i.MX8 AHAB features"
	help
	  This option enables the support for AHAB secure boot.

config BOOTAUX_RESERVED_MEM_BASE
	hex "Define the reserved memory base address"
	default 0x0
	help
	  reserve DDR memory for bootaux

config BOOTAUX_RESERVED_MEM_SIZE
	hex "Define the reserved memory size"
	default 0x0
	help
	  This memory will be reserved by system and linux cannot access.

config IMX8
	bool

config MU_BASE_SPL
	hex "MU base address used in SPL"
	default 0x5d1b0000
	help
	  SPL runs in EL3 mode, it use MU0_A to communicate with SCU.
	  So we could not reuse the one in dts which is for normal U-Boot.

config IMX8QM
	select IMX8
	select SUPPORT_SPL
	select RECOVER_SPL_DATA_SECTION
	bool

config IMX8QXP
	select IMX8
	select SUPPORT_SPL
	select RECOVER_SPL_DATA_SECTION
	bool

config SYS_SOC
	default "imx8"

config SMC_FUSE
        bool "Call fuse commands through SMC"

choice
	prompt "i.MX8 board select"
	optional

config TARGET_IMX8QXP_MEK
	bool "Support i.MX8QXP MEK board"
	select BOARD_LATE_INIT
	select IMX8QXP

config TARGET_IMX8QM_MEK
	bool "Support i.MX8QM MEK board"
	select BOARD_LATE_INIT
	select IMX8QM

config TARGET_IMX8QM_LPDDR4_ARM2
	bool "Support i.MX8QM lpddr4 validation board"
	select BOARD_LATE_INIT
	select IMX8QM

config TARGET_IMX8QM_DDR4_ARM2
	bool "Support i.MX8QM ddr4 validation board"
	select BOARD_LATE_INIT
	select IMX8QM

config TARGET_IMX8QXP_LPDDR4_ARM2
	bool "Support i.MX8QXP lpddr4 validation board"
	select BOARD_LATE_INIT
	select IMX8QXP

config TARGET_IMX8QXP_DDR3_ARM2
	bool "Support i.MX8QXP ddr3 validation board"
	select BOARD_LATE_INIT
	select IMX8QXP

config TARGET_IMX8X_17X17_VAL
	bool "Support i.MX8QXP/DX 17x17 validation board"
	select BOARD_LATE_INIT
	select IMX8QXP

endchoice

source "board/freescale/imx8qxp_mek/Kconfig"
source "board/freescale/imx8qm_mek/Kconfig"
source "board/freescale/imx8qxp_arm2/Kconfig"
source "board/freescale/imx8qm_arm2/Kconfig"

endif