blob: 7f8d18e03b76e752c04e84045b5d0941d4efdc5e [file] [log] [blame]
Intel Stratix 10 SoCFPGA
========================
Stratix 10 SoCFPGA is a FPGA with integrated quad-core 64-bit Arm Cortex A53 processor.
Upon boot, Boot ROM loads bl2 into OCRAM. Bl2 subsequently initializes
the hardware, then loads bl31 and bl33 (UEFI) into DDR and boots to bl33.
::
Boot ROM --> Trusted Firmware-A --> UEFI
How to build
------------
Code Locations
~~~~~~~~~~~~~~
- Trusted Firmware-A:
`link <https://github.com/ARM-software/arm-trusted-firmware>`__
- UEFI (to be updated with new upstreamed UEFI):
`link <https://github.com/altera-opensource/uefi-socfpga>`__
Build Procedure
~~~~~~~~~~~~~~~
- Fetch all the above 2 repositories into local host.
Make all the repositories in the same ${BUILD\_PATH}.
- Prepare the AARCH64 toolchain.
- Build UEFI using Stratix 10 platform as configuration
This will be updated to use an updated UEFI using the latest EDK2 source
.. code:: bash
make CROSS_COMPILE=aarch64-linux-gnu- device=s10
- Build atf providing the previously generated UEFI as the BL33 image
.. code:: bash
make CROSS_COMPILE=aarch64-linux-gnu- bl2 fip PLAT=stratix10
BL33=PEI.ROM
Install Procedure
~~~~~~~~~~~~~~~~~
- dd fip.bin to a A2 partition on the MMC drive to be booted in Stratix 10
board.
- Generate a SOF containing bl2
.. code:: bash
aarch64-linux-gnu-objcopy -I binary -O ihex --change-addresses 0xffe00000 bl2.bin bl2.hex
quartus_cpf --bootloader bl2.hex <quartus_generated_sof> <output_sof_with_bl2>
- Configure SOF to board
.. code:: bash
nios2-configure-sof <output_sof_with_bl2>
Boot trace
----------
::
INFO: DDR: DRAM calibration success.
INFO: ECC is disabled.
INFO: Init HPS NOC's DDR Scheduler.
NOTICE: BL2: v2.0(debug):v2.0-809-g7f8474a-dirty
NOTICE: BL2: Built : 17:38:19, Feb 18 2019
INFO: BL2: Doing platform setup
INFO: BL2: Loading image id 3
INFO: Loading image id=3 at address 0xffe1c000
INFO: Image id=3 loaded: 0xffe1c000 - 0xffe24034
INFO: BL2: Loading image id 5
INFO: Loading image id=5 at address 0x50000
INFO: Image id=5 loaded: 0x50000 - 0x550000
NOTICE: BL2: Booting BL31
INFO: Entry point address = 0xffe1c000
INFO: SPSR = 0x3cd
NOTICE: BL31: v2.0(debug):v2.0-810-g788c436-dirty
NOTICE: BL31: Built : 15:17:16, Feb 20 2019
INFO: ARM GICv2 driver initialized
INFO: BL31: Initializing runtime services
WARNING: BL31: cortex_a53: CPU workaround for 855873 was missing!
INFO: BL31: Preparing for EL3 exit to normal world
INFO: Entry point address = 0x50000
INFO: SPSR = 0x3c9
UEFI firmware (version 1.0 built at 11:26:18 on Nov 7 2018)