| cutter plugin by thomas <thomas@apestaart.org> | |
| SYNOPSIS | |
| This plugin emits signals when RMS level of audio signal crosses a | |
| threshold for a given amount of time. | |
| As soon as the buffer's RMS is greater than the threshold value, the plugin fires a CUT_START signal. | |
| When the buffer's RMS level drops below the threshold value for a consecutive run length longer than the given runlength, it sends a CUT_STOP signal. | |
| When a pre-recording buffer is used, the plugin will delay throughput of data when it's in "silent" mode for a maximum length equal to the pre-recording buffer length. As soon as the input level crosses the threshold level, this pre-recorded buffer is flushed to the src pad (so you can actually record the audio just before the threshold crossing) after sending the signal. | |
| ARGUMENTS | |
| GstCutter::threshold | |
| level (between 0 and 1) of threshold | |
| GstCutter::threshold_dB | |
| level of threshold in dB (between -inf and 0) | |
| GstCutter::runlength | |
| minimum length (in seconds) before plugin sends cut_stop signal | |
| GstCutter::prelength | |
| length of pre-recording buffer | |
| SIGNALS | |
| CUT_START | |
| gets sent when the level of the signal goes above threshold level | |
| CUT_STOP | |
| gets sent when the level of the signal has been below the | |
| threshold level for a number of consecutive iterations of which | |
| the cumulative length is more than the runlength | |
| LIMITATIONS | |
| * RMS value is calculated over the whole data buffer, so | |
| the time resolution is limited to the buffer length | |
| * RMS value is calculated over all of the channels combined |