Overview
========
The sai_interrupt_transfer example shows how to use sai driver with interrupt:

In this example, one sai instance playbacks the audio data stored in flash/SRAM using interrupt.

Toolchain supported
===================
- IAR embedded Workbench  8.50.1
- GCC ARM Embedded  9.2.1

Hardware requirements
=====================
- Micro USB cable
- MIMX8MQ6-EVK  board
- J-Link Debug Probe
- 12V power supply
- Personal Computer
- Headphone

Board settings
==============
No special settings are required.


Prepare the Demo
================
1.  Connect 12V power supply and J-Link Debug Probe to the board, switch SW701 to power on the board
2.  Connect a USB cable between the host PC and the J1701 USB port on the target board.
3.  Open a serial terminal with the following settings:
    - 115200 baud rate
    - 8 data bits
    - No parity
    - One stop bit
    - No flow control
4.  Download the program to the target board.
5.  Launch the debugger in your IDE to begin running the demo.

Running the demo
================
When the demo runs successfully, you can hear the tone and the log would be seen on the terminal like:

~~~~~~~~~~~~~~~~~~~
SAI example started!
SAI example finished!
 ~~~~~~~~~~~~~~~~~~~
Customization options
=====================