[libata] use dev_printk() throughout drivers
A few drivers were not following the standard meme of printing out
their driver name and version at module load time; this is fixed
as well.
diff --git a/drivers/scsi/pdc_adma.c b/drivers/scsi/pdc_adma.c
index 74b3b2c..665017e 100644
--- a/drivers/scsi/pdc_adma.c
+++ b/drivers/scsi/pdc_adma.c
@@ -40,6 +40,7 @@
#include <linux/delay.h>
#include <linux/interrupt.h>
#include <linux/sched.h>
+#include <linux/device.h>
#include "scsi.h"
#include <scsi/scsi_host.h>
#include <asm/io.h>
@@ -626,16 +627,14 @@
rc = pci_set_dma_mask(pdev, DMA_32BIT_MASK);
if (rc) {
- printk(KERN_ERR DRV_NAME
- "(%s): 32-bit DMA enable failed\n",
- pci_name(pdev));
+ dev_printk(KERN_ERR, &pdev->dev,
+ "32-bit DMA enable failed\n");
return rc;
}
rc = pci_set_consistent_dma_mask(pdev, DMA_32BIT_MASK);
if (rc) {
- printk(KERN_ERR DRV_NAME
- "(%s): 32-bit consistent DMA enable failed\n",
- pci_name(pdev));
+ dev_printk(KERN_ERR, &pdev->dev,
+ "32-bit consistent DMA enable failed\n");
return rc;
}
return 0;
@@ -651,7 +650,7 @@
int rc, port_no;
if (!printed_version++)
- printk(KERN_DEBUG DRV_NAME " version " DRV_VERSION "\n");
+ dev_printk(KERN_DEBUG, &pdev->dev, "version " DRV_VERSION "\n");
rc = pci_enable_device(pdev);
if (rc)
