gpio: Add IRQ support to ACCES 104-IDIO-16 driver
The ACCES 104-IDIO-16 series offers Change-of-State detection interrupt
functionality; if Change-of-State detection is enabled, an interrupt is
fired off if any input line changes state (i.e. goes from low to high,
or from high to low). This patch adds support to handle these interrupts
and allows the user to mask which GPIO lines are affected. The interrupt
line number for the device may be set via the idio_16_irq module
parameter.
Signed-off-by: William Breathitt Gray <vilhelm.gray@gmail.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig
index b18bea0..18e1aa05 100644
--- a/drivers/gpio/Kconfig
+++ b/drivers/gpio/Kconfig
@@ -496,8 +496,12 @@
config GPIO_104_IDIO_16
tristate "ACCES 104-IDIO-16 GPIO support"
+ select GPIOLIB_IRQCHIP
help
- Enables GPIO support for the ACCES 104-IDIO-16 family.
+ Enables GPIO support for the ACCES 104-IDIO-16 family. The base port
+ address for the device may be set via the idio_16_base module
+ parameter. The interrupt line number for the device may be set via the
+ idio_16_irq module parameter.
config GPIO_F7188X
tristate "F71869, F71869A, F71882FG and F71889F GPIO support"
