cfg80211: add P2P Device abstraction
In order to support using a different MAC address
for the P2P Device address we must first have a
P2P Device abstraction that can be assigned a MAC
address.
This abstraction will also be useful to support
offloading P2P operations to the device, e.g.
periodic listen for discoverability.
Currently, the driver is responsible for assigning
a MAC address to the P2P Device, but this could be
changed by allowing a MAC address to be given to
the NEW_INTERFACE command.
As it has no associated netdev, a P2P Device can
only be identified by its wdev identifier but the
previous patches allowed using the wdev identifier
in various APIs, e.g. remain-on-channel.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
diff --git a/net/wireless/util.c b/net/wireless/util.c
index ce393dd..d7b6722 100644
--- a/net/wireless/util.c
+++ b/net/wireless/util.c
@@ -800,6 +800,10 @@
if (otype == NL80211_IFTYPE_AP_VLAN)
return -EOPNOTSUPP;
+ /* cannot change into P2P device type */
+ if (ntype == NL80211_IFTYPE_P2P_DEVICE)
+ return -EOPNOTSUPP;
+
if (!rdev->ops->change_virtual_intf ||
!(rdev->wiphy.interface_modes & (1 << ntype)))
return -EOPNOTSUPP;
@@ -877,6 +881,9 @@
case NUM_NL80211_IFTYPES:
/* not happening */
break;
+ case NL80211_IFTYPE_P2P_DEVICE:
+ WARN_ON(1);
+ break;
}
}
@@ -1041,8 +1048,15 @@
list_for_each_entry(wdev_iter, &rdev->wdev_list, list) {
if (wdev_iter == wdev)
continue;
- if (!netif_running(wdev_iter->netdev))
- continue;
+ if (wdev_iter->netdev) {
+ if (!netif_running(wdev_iter->netdev))
+ continue;
+ } else if (wdev_iter->iftype == NL80211_IFTYPE_P2P_DEVICE) {
+ if (!wdev_iter->p2p_started)
+ continue;
+ } else {
+ WARN_ON(1);
+ }
if (rdev->wiphy.software_iftypes & BIT(wdev_iter->iftype))
continue;
