[XFRM]: BEET mode
This patch introduces the BEET mode (Bound End-to-End Tunnel) with as
specified by the ietf draft at the following link:
http://www.ietf.org/internet-drafts/draft-nikander-esp-beet-mode-06.txt
The patch provides only single family support (i.e. inner family =
outer family).
Signed-off-by: Diego Beltrami <diego.beltrami@gmail.com>
Signed-off-by: Miika Komu <miika@iki.fi>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: Abhinav Pathak <abhinav.pathak@hiit.fi>
Signed-off-by: Jeff Ahrenholz <ahrenholz@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/net/ipv4/esp4.c b/net/ipv4/esp4.c
index 13b2936..b5c205b 100644
--- a/net/ipv4/esp4.c
+++ b/net/ipv4/esp4.c
@@ -253,7 +253,8 @@
* as per draft-ietf-ipsec-udp-encaps-06,
* section 3.1.2
*/
- if (x->props.mode == XFRM_MODE_TRANSPORT)
+ if (x->props.mode == XFRM_MODE_TRANSPORT ||
+ x->props.mode == XFRM_MODE_BEET)
skb->ip_summed = CHECKSUM_UNNECESSARY;
}
@@ -271,17 +272,28 @@
{
struct esp_data *esp = x->data;
u32 blksize = ALIGN(crypto_blkcipher_blocksize(esp->conf.tfm), 4);
+ int enclen = 0;
- if (x->props.mode == XFRM_MODE_TUNNEL) {
- mtu = ALIGN(mtu + 2, blksize);
- } else {
- /* The worst case. */
+ switch (x->props.mode) {
+ case XFRM_MODE_TUNNEL:
+ mtu = ALIGN(mtu +2, blksize);
+ break;
+ default:
+ case XFRM_MODE_TRANSPORT:
+ /* The worst case */
mtu = ALIGN(mtu + 2, 4) + blksize - 4;
+ break;
+ case XFRM_MODE_BEET:
+ /* The worst case. */
+ enclen = IPV4_BEET_PHMAXLEN;
+ mtu = ALIGN(mtu + enclen + 2, blksize);
+ break;
}
+
if (esp->conf.padlen)
mtu = ALIGN(mtu, esp->conf.padlen);
- return mtu + x->props.header_len + esp->auth.icv_trunc_len;
+ return mtu + x->props.header_len + esp->auth.icv_trunc_len - enclen;
}
static void esp4_err(struct sk_buff *skb, u32 info)
