fsl/usb: Resolve PHY_CLK_VLD instability issue for ULPI phy
For controller versions greater than 1.6, setting ULPI_PHY_CLK_SEL
bit when USB_EN bit is already set causes instability issues with
PHY_CLK_VLD bit. So USB_EN is set only for IP controller version
below 1.6 before setting ULPI_PHY_CLK_SEL bit
Signed-off-by: Ramneek Mehresh <ramneek.mehresh@freescale.com>
Cc: stable <stable@vger.kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/usb/host/ehci-fsl.c b/drivers/usb/host/ehci-fsl.c
index 4449f56..d3166e6 100644
--- a/drivers/usb/host/ehci-fsl.c
+++ b/drivers/usb/host/ehci-fsl.c
@@ -130,7 +130,7 @@
}
/* Enable USB controller, 83xx or 8536 */
- if (pdata->have_sysif_regs)
+ if (pdata->have_sysif_regs && pdata->controller_ver < FSL_USB_VER_1_6)
setbits32(hcd->regs + FSL_SOC_USB_CTRL, 0x4);
/* Don't need to set host mode here. It will be done by tdi_reset() */
@@ -232,15 +232,9 @@
case FSL_USB2_PHY_ULPI:
if (pdata->have_sysif_regs && pdata->controller_ver) {
/* controller version 1.6 or above */
+ clrbits32(non_ehci + FSL_SOC_USB_CTRL, UTMI_PHY_EN);
setbits32(non_ehci + FSL_SOC_USB_CTRL,
- ULPI_PHY_CLK_SEL);
- /*
- * Due to controller issue of PHY_CLK_VALID in ULPI
- * mode, we set USB_CTRL_USB_EN before checking
- * PHY_CLK_VALID, otherwise PHY_CLK_VALID doesn't work.
- */
- clrsetbits_be32(non_ehci + FSL_SOC_USB_CTRL,
- UTMI_PHY_EN, USB_CTRL_USB_EN);
+ ULPI_PHY_CLK_SEL | USB_CTRL_USB_EN);
}
portsc |= PORT_PTS_ULPI;
break;
